CNP Brands 121340-002 User manual

IMPORTANT: KEEP FOR FUTURE REFERENCE, READ CAREFULLY
1
This product has been designed and manufactured to comply with the Australian Safety Standard AS2088-2009.
safety precautions
Before assembling this adaptor, read and understand the instructions. Incorrect
assembly may make the adaptor unsafe. Do not use this adaptor if any part is
broken, torn or missing. Keep instructions in a safe place for future reference.
Warranty
Thank you for your purchase of this quality product from CNP Brands. To register your 12 month warranty and to
view our warranty conditions, visit www.cnpbrands.com.au.
IMPORTANT
This adaptor is designed for (Orion/Strider/Cruiser) Car Seat; to be used with flat
fold stroller including the followings:
Childcare stroller models: Edge 3
Bebe Care stroller models: Edge 4
Left plastic
adaptor
Right plastic
adaptor
assembly contents
assembly/operating instructions
To attach adaptor
To remove stroller bumper
Insert the set of plastic adaptor into the side stroller frame’s
slots until it ‘clicks’ and locks into place.
In order to install brackets, rst remove existing stroller
bumper bar.
This can be done by lifting and displacing the base of
the bumper bar outwards away from the stroller. While
displaced gently pull the bar towards yourself to remove it.
2
1
front front back back
model # 121340-002
Lift outwards

2
Care and maintenance
To ensure the long-lasting use of your adaptor wipe down with a damp cloth and use a mild soap solution if
necessary. Do not use abrasive cleaners. Always store product in a clean dry place.
Maintenance
Always check parts regularly for tightness of screws, nuts and other fasteners – tighten or replace if required. To
maintain the safety of your adaptor, seek prompt repairs for bent, torn, worn or broken parts. Use only those parts
and accessories approved by CNP Brands.
how to care for your Childcare adaptor
To remove adaptor - optional
To release the plastic adaptor from stroller, push adaptor
towards inside of stroller, then unclip. Lift out as shown in
diagram.
1.
2.
assembly/operating instructions (cont.)
Insert car seat into adaptor
Insert the Orion/Strider/Cruiser Car Seat as per car seat
manufacturer’s instructions by aligning the plastic side parts
of the car seat into the corresponding adaptor.
Push down until it sits into place.
Simultaneously swing the car seat’s handle down while
pressing both grey lever on the car seat’s side handle
moulds until it locks into position.
WARNING: Lift the Orion/Strider/Cruiser Car Seat upwards to
ensure that it’s fully engaged and locked before use.
1
2
grey lever
grey lever
To remove car seat from stroller frame
Simultaneously swing the car seat’s handle up while
pressing both grey lever on the car seat’s side handle
moulds to release the car seat.
Lift it up via the handle.
1
2
3
model # 121340-002
Folding stroller
WARNING: both plastic adaptors can remain attached to the
stroller frame when folding stroller.
Fold the stroller as per stroller manufacturer’s folding
instructions.