Coaster 100958 User manual

100958
COUNTER HEIGHT TABLE WITH STORAGE
BASE
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
REVISION 0 : 06/26/2011
PAGE 1 OF 6
www.coastercompany.com
REVISION 0 : 06/26/2011
REVISION 1 : 09/19/2011

ASSEMBLY INSTRUCTIONS
HARDWARE IDENTIFICATION
ATABLE TOP 1PC 1ALLEN WRENCH 1PC
2
BOLT
12PCS
BLEG FRAME 2PCS
34PCS
CTOP PANEL 1PC
4
FLAT WASHER
4PCS
ITEM :
100958
PARTS IDENTIFICATION
ALLEN CAP SCREW
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishment
4
FLAT WASHER
4PCS
BOTTOM PANEL 1PC 5
METAL PIN
4PCS
D
6DOWEL 2PCS
E2PCS
72PCS
82PCS
F
2PCS
98PCS
G1PC
HCUSHION PAD 2PCS
www.coastercompany.com
DOOR WITH
CUSHION PAD
PANEL WITH
GLASS HOLDER
MAGNETIC CATCH
PLATE
FLAT HEAD
SCREW
TRAY PANEL
MAGNETIC CATCH
www.coastercompany.com
PAGE 2 OF 6

ASSEMBLY INSTRUCTIONS
STEP 1
Align and fasten magnetic catch to top panel using flat
head screw and tighten with screw driver (Not included).
100958
ITEM :
Align and fasten magnetic catch plate to door using
flat head screw and tighten with screw driver (Not
included).
STEP 2
www.coastercompany.com
Align and fasten top and bottom panels to leg frame using bolt and tighten with allen wrench.
www.coastercompany.com
PAGE 3 OF 6

ASSEMBLY INSTRUCTIONS
STEP 3
100958
ITEM :
Align and insert tray panels into leg frame.
STEP 4
www.coastercompany.com
Align and insert half of metal pin into door and the other half of metal pin into leg.
www.coastercompany.com
PAGE 4 OF 6

ASSEMBLY INSTRUCTIONS
STEP 5
100958
ITEM :
Align and fasten the other leg frame to bottom and top panel using bolt and tighten with allen wrench.
STEP 6
www.coastercompany.com
Align and fasten panel with glass holder to legs with allen cap screw and tighten with allen wrench. Align and insert
dowel into panel with glass holder.
www.coastercompany.com
PAGE 5 OF 6

ASSEMBLY INSTRUCTIONS
STEP 7
100958
ITEM :
Place table top upside down on soft surface, align and fasten the assembled table base to table top using bolt and flat
washer and tighten with allen wrench.
STEP 8
www.coastercompany.com
Flip table using two people to lift and flip this table. Align and attached cushion pad to leg frame.
www.coastercompany.com
PAGE 6 OF 6