COASTLINE 316 User manual

Page 1
REV A
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING. Carefully remove contents
from box. Make sure that all parts and hardware are included using the Parts List below.
COASTLINE CASUAL
11 Industrial Drive
Coventry, Rhode Island 02816
ASSEMBLY INSTRUCTIONS
CAFÉ FUSION DINING CHAIR
316 (Bar Height Frame)
318 (Dining Height Frame)
319 (Slats)
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
80mm Hex Lag (Actual Size)
Part Code: 316-1/4-10-80HL 318 x 4
5/16” Nylon Dowel
Part Code:
NYLON-5/16X1-1/8D x 4 Part Code: 4MMALLEN
4mm Allen Wrench (Actual Size)
x 1
318 x 8
Part Code: TAP-5/8
5/8” tap® (Actual Size)
Part Code: 316-8x1-3/4PFDS
1-3/4 Phillips Head Screw (Actual Size)
318 x 14 x 4
3/8” tap® (Actual Size)
Part Code: TAP-3/8
Left & Right Sides
Front
Aprons
x 1ea
Seat Assembly
x 1
Back Slats
x 2
316 319
Rear
Left Right
x 1ea
318
Left & Right Sides
Stretchers &
Aprons
x 1ea
Rear Apron
Left Right
Foot Rest
X 2
Front Apron & Rear Lower
X 1
X 1
316 x 18
316 x 8 316 x 8

Page 2
REV A
Attach Foot Rest and
Rear Stretcher as shown,
with pockets of Stretchers
facing down, using (4)
80mm Hex Lags through
counter-bored holes in
Legs. Align straight, then
secure using (4) 1-3/4”
screws through pockets
on underside of Foot Rest
and Rear Stretcher.
Attach front and rear
aprons to Side As-
semblies as shown,
with the pockets of
the aprons facing
down using (4) 80mm
Hex Lags through
counter-bored holes
in Legs.
2ATTACH APRONS TO SIDE
ASSEMBLIES 3ATTACH BACK SLATS TO REAR LEGS 4SEAT TO SIDE ASSEMBLIES
6ATTACH FOOTREST AND LOWER REAR
STRETCHER (316 ONLY)
7PLUG ALL HOLES WITH PROVIDED 5/8” AND 3/8” taps™
Align seat assem-
bly with frame.
Secure using 1-
3/4” Philips head
screws through
countersink holes
on inside of seat
assembly into pi-
lot holes in side
assemblies.
Tap 5/16” dowels into
large holes in back
slats. Align with large
holes in rear legs.
Secure with 1-3/4”
Phillips head screws
through 3/8” counter-
bore in Rear Legs
into pilot holes in
back slats.
At this time make sure
lags from step 2 are tight.
Rotate rear apron to align
with angle on seat sup-
port, and make sure front
apron is parallel with front
leg. Secure aprons with 1-
3/4” Philips head screws
through the pockets on
underside of aprons into
legs.
5SECURE APRONS TO LEGS