COASTLINE CAFE FUSION 318 User manual

Page 1
REV A
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING. Carefully remove contents from
box. Make sure that all parts and hardware are included using the Parts List below.
COASTLINE CASUAL
11 Industrial Drive
ASSEMBLY INSTRUCTIONS
CAFÉ FUSION DINING CHAIR
318 (Frame)
319 (Slats)
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
80mm Hex Lag (Actual Size)
Part Code: 316-1/4-10-80HL x 4
5/16” Nylon Dowel (Actual Size)
Part Code: NYLON-5/16X1-1/8D x 2
Part Code: 4MMALLEN
4mm Allen Wrench (Actual Size)
x 1
x 4
Part Code: TAP-5/8
5/8” tap® (Actual Size)
Part Code: 316-8x1-3/4PFDS
1-3/4 Phillips Head Screw (Actual Size)
x 14
x 4
3/8” tap® (Actual Size)
Part Code: TAP-3/8
Left & Right Sides
x 1ea
Front and Rear Apron
x 1ea
Seat Assembly
x 1
Back Slats
x 2
318
319
Front
Rear
Left Right

Page 2
REV A
At this time make sure
lags from step 2 are tight.
Rotate rear apron to align
with angle on seat sup-
port, and make sure front
apron is parallel with front
leg. Secure aprons with 1-
3/4” Philips head screws
through the pockets on
underside of aprons into
legs.
Attach front and rear aprons to
Side assemblies as shown,
with the pockets of the aprons
facing down using (4) 80mm
Hex Lags.
2ATTACH APRONS TO SIDE ASSEMBLIES 3ATTACH BACK SLATS TO REAR LEGS
4SEAT TO SIDE ASSEMBLIES 5SECURE APRONS TO LEGS
6PLUG ALL HOLES WITH PROVIDED 5/8” AND 3/8” taps™
Align seat assembly with
frame. Secure using 1-3/4”
Philips head screws through
countersink holes on inside of
seat assembly into pilot holes
in side assemblies.
Tap 5/16” dowels into large
holes in back slats. Align
with large holes in rear
legs. Secure with 1-3/4”
Phillips head screws
through 3/8” counter-bore
in rear legs into pilot holes
in back slats.