Cobra microTALK MT 200 User manual

LLCCDD
DDiissppllaayy
SSppeeaakkeerr//
MMiiccrroopphhoonnee//
CChhaarrggeeJJaacckk
CCaallllBBuuttttoonn
TTaallkkBBuuttttoonn
Press and hold to communicate
with others. With the microphone
about five cm (2 inches) from your
mouth, speak in a normal voice.
Release the Talk button when you
are finished talking and listen for a
response. You cannot receive
incoming calls while pressing the
Talk button.
NOTE Both radios must be
tuned to the same channel
to communicate.
Press and release to alert
others that you are calling.
TWO-WAY RADIO MODEL
MT 200
Nothing Comes Close to a Cobra®English
RRaaddiiooCCoonnttrroollss
aannddIInnddiiccaattoorrss
Printed in the Philippines
Part No. 480-255-P
Version A
MMooddee//PPoowweerrBBuuttttoonn
UUpp//DDoowwnnBBuuttttoonnss
Press and hold to turn
the radio on or off.
Press and release to
enter mode function to
change channels.
The channel numbers
will blink when that
mode is selected. Use
the Up/Down buttons
to select a channel.
Press and release to
adjust the volume.
While in mode
function, press and
release to change
channels.
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 1

WWaallllCChhaarrggeerr
BBaatttteerriieessaanndd
WWaallllCChhaarrggeerr
BBaatttteerryy
CCoommppaarrttmmeenntt
CCoovveerr
AAnntteennnnaa
BBeellttCClliipp
WWaallllCChhaarrggeerr
BBaatttteerriieess
TTooiinnssttaalllloorrrreeppllaacceebbaatttteerriieess::
1. Remove belt clip by releasing belt
clip latch and sliding clip up.
2. Pull up on the battery door latch to
remove the battery compartment
cover.
3. Insert the supplied three AAA
rechargeable batteries (also works
with non-rechargeable alkaline bat-
teries). Position batteries according
to polarity markings.
4. Replace battery compartment cover
and belt clip.
IInnsseerrttBBaatttteerriieess
PPuullllLLaattcchhUUpp
RReemmoovveeBBeellttCClliipp
RRaaddiiooCChhaarrggeerrJJaacckk
22EEnngglliisshh
TToocchhaarrggeebbaatttteerriieessiinnrraaddiioo::
1. Check to see that the batteries
have been inserted properly.
See above for battery installation
instructions.
2. Insert round connector of wall charger into the charge jack
located at the top of the radio. The wall charger has two
round connectors which enables you to charge either
one or two radios at a time.
3. Plug the wall charger into electrical outlet.
It normally takes 15 hours to fully recharge batteries. It is not
recommended to recharge batteries more than 24 hours. Estimated
operation time on a full charge is 8 hours.
Use only the supplied rechargeable batteries and wall charger
for recharging your Cobra microTALK®radio. Non-rechargeable
alkaline batteries can also be used.
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 2

BBaacckklliittLLCCDDDDiissppllaayy
33EEnngglliisshh
BBaatttteerryyLLoowwIIccoonn
Blinks when battery power level is low.
Your microTALK®radio has a unique circuit
designed to extend battery life. If there are no
transmissions within 10 seconds, the radio
will automatically switch to Battery Save mode.
This will not affect the radio’s ability to receive
incoming transmissions.
CChhaannnneellNNuummbbeerr
While in Standby mode or when selecting a
channel, shows current channel (1 through 8).
When adjusting the volume, shows current level
(1 through 8).
CChhaannnneell//VVoolluummeeIInnddiiccaattoorr
“CH” is visible when in Standby mode or when
selecting a channel.
“LE” is visible when adjusting volume.
TTrraannssmmiittIIccoonn
RReecceeiivveeIIccoonn
Visible when transmitting
a message.
Visible when receiving
a message.
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 3

Declaration of Conformity
This declaration is the responsibility of the
manufacturer/importer
Cobra Electronics Europe Limited
Dungar House
Northumberland Avenue
Dun Laoghaire
County Dublin, Ireland
Date: 21 November 2005
This certifies that the following designated product
PRIVATE MOBILE RADIO: MT 200
complies with the essential protection requirements
of R & TTE Directive 1999/5/EC on the approximation
of the laws of the Member States relating to Radio
Spectrum Matters, EMC and Electrical Safety.
This declaration applies to all specimens
manufactured in accordance with the attached
technical documentation described in Annex II
of the Directive which forms part of this declaration.
Assessment of compliance of the product (class 2.6)
with the requirements relating to the essential
requirements according to Article 3 R & TTE was
based on Annex IV of Directive 1999/5/EC and the
following standards:
Radio Spectrum: EN 300 296-1 V1.1.1 (2001-03)
EN 300 296-2 V1.1.1 (2001-03)
EMC: EN 301 489-1 V1.4.1 (2002-08)
EN 301 489-5 V1.3.1 (2002-08)
Electrical Safety: IEC 60950-1:2001 /
EN 60950-1:2001
RF Exposure: EN 50392 (2004-02)
DUBLIN, IRELAND MIKE KAVANAGH
0682
For use in EU countries, subject to local laws
and regulations.
CEEL™ is a trademark of
Cobra Electronics Corporation, USA.
Snake design and microTALK®are registered
trademarks of Cobra Electronics Corporation, USA.
©2006 Cobra®Electronics Europe Limited
Dungar House, Northumberland Avenue
Dun Laoghaire, County Dublin, Ireland
www.cobra.com
DD..OO..CC..,,WWaarrrraannttyyaanndd
CCuussttoommeerrSSeerrvviiccee
Warranty & Customer Service
For warranty and customer service
information, please contact your
local dealer.
44EEnngglliisshh
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 4