Code Alarm CATX510 Operating instructions

Model CATX510
Programming Guide
The keychain transmitters included with the system have been pre-
programmed at the factory, with each button pre-assigned to control a specific
function of the system.
The system will store codes from up to 4 different transmitters. If a 5th
transmitter is programmed to the system, then the first transmitter
programmed to the system will be erased from the system’s memory.
To program new or additional transmitters:
1. Enter the vehicle, and turn the ignition switch to the ON position.
2. Press and release the programming button switch 3 times.
3. The dash mounted LED will flash 1 time, and the parking lights will flash 1
time, indicating that the system is ready to accept programming of channel 1
which is LOCK.
4. Press and hold the lock icon button of the transmitter you wish to program
for 4 seconds or until a long flash from the parking lights.
4a. Repeat step 4 for any additional transmitter you wish to program.
5. Press and release the programming button switch 1 time to advance to
channel 2. The parking lights will flash 2 times and the dash mounted LED will
flash 2 times, indicating that the system is ready to accept programming for
channel 2 which is UNLOCK.
6. Press and hold the unlock icon button of the transmitter you wish to
program for 4 seconds or until a long flash from the parking lights.
6a. Repeat step 6 for any additional transmitter you wish to program.
7. Press and release the programming button switch 1 time to advance to
channel 3. The parking lights will flash 3 times and the dash mounted LED will
flash 3 times, indicating that the system is ready to accept programming for
channel 3 which is REMOTE START.
8. Press and hold both buttons simultaneously of the transmitter you wish to
program for 4 seconds or until a long flash from the parking lights.
8a. Repeat step 8 for any additional transmitter you wish to program.

Changing the Remote Control Battery
The 12-volt alkaline battery supplied in your remote
transmitter should last approximately one year, depending on
usage. When the battery begins to weaken, you will notice a
decrease in range, or the distance from your vehicle that
your remote transmitter will operate. Follow the instructions
below to change the remote transmitter battery.
For Customer Service and Product information Call
1-800-421-3209
1. Insert the edge of a coin into the slot at the side of the
remote control. Twist the coin to pry the remote control
halves apart.
2. Remove the old battery and replace with a new one.
Be sure to observe the (+) and (-) signs in the battery
compartment.
3. Carefully snap the case halves back together, then test
the remote control.
Model CATX510
Programming Guide