Code Alarm CATX520 Operating instructions

Model CATX520
Programming Guide
1. Enter the vehicle and turn the ignition key to the ON position.
2. Press and release the programming switch 3 times.
The parking lights will flash 1 time, indicating the system is ready to accept
programming for LOCK.
3. Press and hold the LOCK icon button on the transmitter you wish to program for 4
seconds or until you see a long flash of the parking lights.
Repeat step 3 for each additional transmitter you wish to program.
4. Turn the ignition key to the off position and test the functions on the transmitters.
BUTTON SYSTEM FUNCTION
Lock - System will Lock the doors.
Unlock - System will Unlock the doors.
Trunk Release or optional device
connected to channel 3.
When pressed and release two times,
will provide pulsed output or activate the
Remote Start option when installed.
Transmitter Programming Guide

Changing the Remote Control Battery
The 12-volt alkaline battery supplied in your remote
transmitter should last approximately one year, depending on
usage. When the battery begins to weaken, you will notice a
decrease in range, or the distance from your vehicle that
your remote transmitter will operate. Follow the instructions
below to change the remote transmitter battery.
For Customer Service and Product information Call
1-800-421-3209
1. Insert the edge of a coin into the slot at the side of the
remote control. Twist the coin to pry the remote control
halves apart.
2. Remove the old battery and replace with a new one.
Be sure to observe the (+) and (-) signs in the battery
compartment.
3. Carefully snap the case halves back together, then test
the remote control.
Model CATX520
Programming Guide