Code Alarm Professional 1000 User manual

C:OOc~7wIlA ~rn
nClBClClY ELSE IS Wi=' TCl CClClE
OWNER'S MANUAL·
PROFESSIONAL SERIES
1000
1000SX
3000
ELITE SERIES
DM 1500

,
Turn theignitionkey off and exitthevehicle. Press
the arming button (refer to multi- car operation to determine button
function) on theremote controltransmitter. The siren will emit2short arm
"chirps"
to indicate that thesystem is fully armed. A single shOrt "chirp" in-
Idic:at,.sthatone of the protected entrypointshas been·)eftopen. The siren
will emitthe 2nd arm "chirp" 1second afterthe entry point is closed.
U,&!m;;H'IJl.u!~A!&r!!'l!l~z;' Turn off theignition key and exitthevehicle.
1 minute afterexiting the vehicle the siren will emit2 short arm "chirps" to
indicate that thesystem is fully armed. A single short 'chirp" indicates that
one of the protected entrypaintshas been leftopen. The sirenwill emitthe
2nd arm "chirp' 1second afterthe entry paint is closed. "
DISARMING THE SYSTEM
~With the system armed, press the disarm
button on the remote control transmitter.
The siren will emit one long "chirp" (about
twice the duration of the arm "chirps") to
indicate that thesystem is fullydisarmed. The
dash mount status light will turn off. The
Jvehicle can now be started normally.
l!IEMERGENCY OVERRIDE BUTTON:
In the event of a lost transmitter, enter the
vehicle,turn ontheignitionswitch,then
press
the hidden disarm button to disarm the
vehicle.
, Automatic arming systems will auto-
matically re-arm 1minute after disarm.
The
ignition or valet override switch must be
turned on within 1 minute to prevent auto-
matic re-arm.
ARM/ nr::::l
DISARMUL:J

,
o The valet function allows you to prevent the system from arming when
vehicle
is being serviced or parked by a valet. To operate. simply
disarm
the system then turn the valetswitch to the "ON·" position before
arming the system. The system will remain in the valetstate as long
as the valetswitch remains in the "ON" position. The system will arm
normally when the valet switch is returned to the "Q!!" position.
the alarm is in the valetstate. the L.E.D. indicatorwill flash in a
blink sequence (2-blinks
"on"; then "off" ... ). In valetstate your remote
control transmitter
will still lock and unlock your doors but will not arm
your vehicle. It
\/iiill only emit one chirp as if an entry point was left open.
Some states do not allow a premium insurance discount for alarm
equipped vehicleswhen the service/valetoverride switch is used. Check
with
REMOTE CONTROL PANIC BUTTON OPERATION
f! With the system armed or disarmed. press both buttons on the remote
control transmitter at the same time.
The siren will turn on and remain
activefor 30 seconds.
The siren can be turned off before 30 seconds
by pressing any button on the remote control transmitter.
Your system
is capable of
recognizing 4 differenttransmit-
ters having 4 different codes.
o TWO-CAR OPERATION: In
this mode each transmitter can
control two cars. Both cars must
have alarms with 2car capability.
ARMI ~ ARMI
DISARM . DISARM
CAR 1 CAR 2
PRESS AND HOLD
DISARM BUTTON
FOR TRUNK

,
-Fast blink: Tripped
-Double blink:
In valet
-Slow blink: Armed
-Off: Disarmed
I!{UTE- TOUCH SHOCK SENSOR: Providesyour vehicle with customc
izedsensitivity to detect sharpblows tothe doors. hood. trunk and windows
yet ignore such soundsas wind.rain.horns or passing traffic .. Non-threat-
ening lightblowswill not set off youralarm. but will trigger a warning "chirp".
The Lite Touch ShockSensor will trigger the alarm ifa harder blow impacts
the vehicle.(Lite-Touch is not availible on Pro. 1000 and the Elite DM1500)

,
-. ,.
IB:If...u;~~lE!~~~ttt When you disarm your system, the siren will
emit a series of" Chirps", if the alarm was tripped in your absence. To
identify what tripped your system push the emergency override button
before turning the ignition on.
1
CHIRP -Shock Sensor was tripped.
2
CHIRPS -Ignition has been turned "ON".
3 CHIRPS -Door Sensor was triggered (Ford vehicles only)
4 CHIRPS -Door Sensor was triggered (G. M" Chrysler. Importvehicles) or
Hood/Trunk was triggered.
SCAN PETERRENT: This alarm is designed to preventany attempt
by a thief to disarm your system by electronically scanning your per-
sonal transmitter
code.
COPE LEARNING: Dealer can programsystem on the spot to learn
up to four new transmitter codes should origircal transmitter be lost or
stolen. Since
new codes do not have to be specially ordered,your
vehicle will
not go unprotected.
AUTOMATIC REARM AFTER TRIP CYCLE: If alarm is tripped, siren
sounds for 60 seconds, then siren stops and system rearms itself. If a thief
returns
to try again, he returns to an armed vehicle.'
CONTINUOUS OPEN POOR MONITOR: If a potential thief
attempts a break-in
and leaves the vehicle door ajar, alarm sounds for
one minute, then turns off. This cycle is repeated five times to draw'extra
attention
to the vehicle while keeping the vehicle armed and al'ert.

,
AUTOMATIC POWER OOORLOCK: When selected, the
system will automatically lock the vehicle doors when the alarm
completes
the automatic armingcycle.
NOTE: Selecting this function will lock the doors even if the keys are
accidently left in the ignition or In the vehicle.
Interior lights automatically turn on
whenyouturn the ignition key off forvehicleexit and whenyou disarm the
system for vehicle entry. Provides lighted exit. and entry for increased
nighttime security.
Press the arm/disarm buttor\' on your transmitter to
disarm the system (longdisarm "chirp"), The interiorlightswill illuminate for
1minute or until ignition key
is turned on.
Flashes parkinglightswhen the alarm
is trippedfor increasedattention. Also flashes parkinglights,alongwith (or
instead of)arm/disarm "chirps".
CHECK
The system should be tested periodically for proper operation, Arm the
system, wait at least5seconds after youhear the secondarm "chirp", then'
test all protected entry pOints. When entry point is violated, the siren will
sound for 60 seconds followed by a 10 second off time. This cycle will
repeat as long as an entry point is beingviolated. Consultyour dealer for
sensor operation.
If you encounter a problem, consult your dealer,

,
"
,'
SYSTEM MAINTENANCE/SERVICE
The system requires no specificmaintenance, YourCode-Alarmdealerisfully
qualified to properly seNice all
system components should a problem arise.
The life expectancy of thetransmitter battery is approximately 1year
may be longer depending on actual use. Decreasing transmitter range i
an indication
of a weakening battery. To access the transmitter battery;
1
. Use a small phillips head screwdriver to remove the case screVf on the
back of the transmitter. 2. Remove the back cover to access the battery.
3, Carefully remove the battery and replace It with a 12V cigarette lighter
battery (Duracell-Type MN21, Gold Peak-Type GP23A or orderfrom your
dealer). Make sure the battery's (-) & (+) sides are placed into transmitter
properly.
During ideal conditions your
CODE ALARM security system is designed to
operate via remote control at a range of approximately 50 feet from your
vehicle. Although you may at times experience range greaterthan 50 feet,
are certain conditions that will cause the transmitter range to be less
what you would normally experience, Atmospheric conditions and
radio interference are just a few examples of the types of interference that
can reduce transmitter range, If you experience conditions whichwill not
allow your transmitter to disarm your vehicie, then use your emergency
override button inside thevehicle.
This will disarm the system and allow you
startyour vehicle. Move yourvehicie to a differentlocation,
If problem
occurring,
check yourtransmitter battery orsee your dealer,

,
:',
When a CODE-ALARM Professional or Elite Series system has been installed in
your vehicle, CODE-Al,ARM will pay you the following amounts
if your vehicle
should be stolen within the first year following the system's installation.
PROFESSIONAL ELITE
1000 -$500.00 DM1500 -$1000.00
$1000.00 .
$2000.00
OOOSX -$1000.00
$1000.00
$2000.00
$2000.00
2000 -
4000 -
6000 -
COMPETITION -$3000.00
$3000.00
In orderto qualify for this theft protection guarantee, the following restrictions
apply:
. The vehicle's owner as well as the dealer/installer must complete and
submit to CODE-ALARM the Theft Protection Guarantee Registration
Form within thirty (30) days from purchase to verify that the system was
installed.
The system must be installed by an authorized CODE ALARM Dealer.
The vehicle in which the system has been installed must be not more
than three (3) years old from the date of original purchase of the vehicle.
The vehicle
in which the system has been installed must be missing for
thirty (30) days
or more.
A copy
of the police report of the missing veflicle and a copy of the paid
theft insurance claim
on that same vehicle, arid a copy of original receipt
of purchase must be submitted to CODE-ALARM. The original owner
as used herein shall mean the owner ofthe vehicle at the time of the
original registration with the CODE-ALARM.
When all the above qualifications have been met, a reimbursement check will be
out to the vehicle's owner and to the installing dealer.
URANCE REGISTRATION FOR DISCOUNT PROG
In some states your insurance company may offer you a 5-20% discount for
installing a CODE-ALARM, INC. Alarm System. Check with your insurance
for details. This form may serve as proof of installation.
: ":::======:a~;mc;;;;r;;:--:illE installed a CODE-ALARM System in my
1_ The CODE-ALARM System was installed on
1~~~~amcebY~~------------
:~ policy # ---;-:-;---;-~--;- _____ _
'1I<,hirIA Year -=cc-- Make Model _______ __
IIIAt,idA ID# (VIN) _________ -:-::-:-==- ___________ _

"
,
Products manufactured by CODE-ALARM are warranted by the company to the
original consumer purchaser to be free from defects in workmanship and
material. Should a product be found defective without charge during the lifetime
of the vehicle in which it was originally installed, CODE-ALARM shall repair or
replace the product
or any part of the product which CODE-ALARM agrees is
defective without charge during the first year provided the product is returned to
CODE-ALARM freight prepaid and accompanied by a copy of the purchase
receipt. After one year a ten dollar charge will be required to cover "hinninn
'"ni
handling after service,
The warranty described
in the paragraph above shall apply to products manufac-
tured and sold by CODE-ALARM. Products sold by, but not manufacturep by
CODE-ALARM are warranted by CODE-ALARM for a period of one year from the
date of purchase by the original consumer and purchaser.
This warranty does not apply to any product damaged by accident, physical
or
electrical misuse or abuse, improper installation, alteration, any use contrary to
its intended function, unauthorized service (i.e. service by anyone other than the
Company
or its authorized service personnel), fire, flood, lightning, or other acts
of God.
The Company shall not be responsible for removal andlor reinSlallation charges,
damage to or theft of the vehicle or its contents, or any incidental or consequen-
tial damages caused by any failure
of the product to function properly. Under no
circumstances should this warranty, or the product covered by
it, be construed as
an insurance policy against loss. The Company neither assumes nor authorizes
any person or organization to make ANY WARRANTIES or assume any liability
in connection with the sale, installation, or use of this product. This is the
,nn1nI"tA CODE-ALARM warranty and no other warranty exists.
o Automatic
o Manual
o Remote
o Starter Interrupt
Owner Signature: ___________ _