GB
Insert the ac-adapter jack completly in the power input
To disconnect it, extract gently.
ATTENTION: do not use ac-adapter different from the one supplied,
it could cause serious damages at the internal circuitation.
The supplied ac-adapter has a plug, therefore you should only plug it in
the socket.
When
Wi D Pen is powered
, the led indicate for three seconds its state (rreedd
ggrreeeennoorrbblluuee), if this condition is not true, please check if there is power in the
electric socket or check the connection between ac-adapter/receiver and ac-
adapter/electric socket.
If the problem persist, please consult your dealer.
To supply WWiiDDPPeennfrom the projector you must provide a vol-
tage between +5Vdc and 8Vdc (200 mA) to pin 4 of the DMX
input XLR connector (see fig.1).
If the projector has the
logo, just connect
WWiiDDPPeennwithout ac adapter.
TToottuurrnnoonn//oofffftthheelleeddbblliinnkkiinnggeevveerryy1100sseeccoonndd,,
press the key 5 time.
TToovviissuuaalliizzeetthheessttaatteeoofftthheerreecceeiivveerr,,press the key once,
the led visualizes the state for two seconds.
TTooddeelleetteePPaaiirriinngg,,press the key for more than 5seconds,
the led starts blinking red/green/blue.
Slow blinking: Receiver OOKK, no DDMMXX551122signal.
Fast blinking: Channel research.
Switched on, then blinking every 10 second: DDMMXX551122signal OOKK.
Alternate blinking: No Pairing.