Colebrook Bosson Saunders Loop CPU/012 Instruction Manual

Installation Instructions
for Loop CPU holder
CPU/012PARTS INCLUDED:
Loop CPU
Holder
M8
Locknut
CPU-012-INST-B-SEPT 2017
WARNING
• Ensure desk is suitable to take the weight of the CPU holder and CPU.
• Do not use this product for any purpose other than that for which it was designed.
• Hold the CPU tightly when making adjustments.
• Care should be taken to avoid trapping ngers.
• Do not dismantle or modify the CPU cradle.
• Supported weight must not exceed 20kg (44.1lb) per cradle.
MAINTENANCE AND INSPECTION
• Ensure all screws and xings are fully tightened and occasionally re-tighten if necessary.
• Clean with a dampcloth. DO NOT use solvents.
DISCLAIMER
• The use of power tools, lever bars or excessive force during the installation, or
reconguration of the product will invalidate your guarantee.
• Failure to observe the recommendations in the use, and conguration of these products
may aect your guarantee.
• As part of Colebrook Bosson Saunders ongoing product improvement programme, the
design of products may change without prior notice and details may vary from those illustrated.
CPU/012
Keyed metal
washer
Nylon
washer
Allen
Key
CPU DESK FITTING SUPPLIED SEPERATELY
240
500
80 225
Min/Max CPU Dimensions
2
0
K
G
/
4
4
.
1
L
B
MAX
PATENTS
Colebrook Bosson Saunders hold a number of patents and other
intellectual property rights covering our products and processes.
You can nd patent information on our website at:
www.colebrookbossonsaunders.com/patents

REMOVE ALLEN KEY, NUT AND WASHERS
FROM LOOP CPU HOLDER
1TAKE SLIDER FROM CPU FIXING KIT
(ORDERED SEPERATELY) AND FIT INTO POSITION
2
TIGHTEN WASHER AND LOCK NUT ONTO PIN
3
IMPORTANT NOTE
Ensure nut is fully tightened
(6nm recommended
minimum torque)
SLIDE CPU INTO THE LOOP
4
IMPORTANT NOTE
Moulding should be positioned
in the centre of the CPU
ROLL RATCHET WHEEL
TO TIGHTEN STRAP TO CPU
5ADDITIONAL TIGHTENING
REQUIRED USING ALLEN
KEY PROVIDED
6PLACE ALLEN KEY INTO
STORAGE HOLE
7
MOUNTING CPU FIXING KIT TO DESK
8
Make sure the CPU
will be able to rotate
from side to side
[OPTIONAL] TO REMOVE LOOP
9
Unmount CPU from desk following
reverse procedure from step 8c
Use tool to push down on release button
and hold whilst pulling strap downwards
IMPORTANT NOTE
Ensure strap is fully tightened
8A 8B
8C