Colorado Video 619HWY User manual

instruction manual
Model 619HWY
video dual cross hair generator
s/n_______________
november 2008

WARNING
This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instruction manual, may cause interference to radio
communications.
It has been tested and found to comply with the limits for a class A computing device
pursuant to subpart of J of part 15 of CC Rules, which are designed to provide reasonable
protection against such interference when operated in a commercial environment. Operation
of this equipment in a residential area is likely to cause interference in which case the user at
his own expense will be required to take whatever measures may be required to correct the
interference.
2

TABLE OF CONTENTS
Section I GENERAL DESCRIPTION Page
1.1 Introduction 4
1.2 Purpose of Equipment 4
1.3 . Description of Equipment 4
1.4 .Specifications 5
Section II OPERATING INSTRUCTIONS 6
2.1. Introduction 6
2.2 . Installation and Operation 6
2.3 . Operation 6
3

1.1 INTRODUCTION
This instruction manual is to be used as a guide to the installation, adjustment,
operation and maintenance of the Colorado Video Model 619HWY Dual Cross Hair
Generator.
1. PURPOSE OF EQUIPMENT
The Model 619HWY Video Dual Cross Hair generator is used to generate
lines on a television screen. It allows rapid alignment of subject material with a
predetermined location when used in conjunction with a standard TV camera and monitor.
1.3 DESCRIPTION OF EQUIPMENT
The Model 619HWY accepts composite video input, adds full raster lines to
the video and provides a composite video output of the video lines for display on a standard
TV monitor. The position of the lines can be varied over 90% of the raster width using the
front panel controls.
4

1.4 SPECIFICATIONS
Size: 6.9”W x 4.9”L x .5”H excluding controls and connectors
Mounting: Free standing
Construction: Solid-state PC Board in ABS case
Power: +1 VDC
Input Signal: Video, composite, 1 V p-p, 75 Ω, internal termination
Output Signal: Video, composite, 1 V p-p, 75Ω
Operating
controls: H position ( ): <90% of raster
V position ( ): <90% of raster
Solid/Dashed (switch)
/1 sets of lines (switch)
Lines Black/Off/White (switch)
Connectors: Video In: BNC
Video-Out: BNC
Power: .5mm coaxial, center pin positive
.3.3 Internal Controls - Factory Set
Control Function
Line Length ( ) Adjusts length of horizontal line
at right end.
5

SECTION II
OPERATING INSTRUCTIONS
.1 INTRODUCTION
This section contains the general operating instructions and procedures for the
Model 619HWY Video Dual Cross Hair Generator.
. INSTALLATION AND OPERATION
Connect a camera or other source of a composite video signal to the VIDEO IN
connector on the rear of the 619HWY. Connect a video monitor to the VIDEO OUT
connector.
Apply power to the camera, monitor and the 619HWY. Be sure to use only a 5VDC
regulated power supply for the Model 619HWY. Any other type of supply could cause an
unstable line display or damage to the unit. The monitor will display the subject viewed by
the camera with Dual Cross hair superimposed.
Adjust the position controls on top panel. The cursor lines should move.
.3 CONTROLS
.3.1 OPERATING CONTROLS
Control Location unction
H Position (2)Top Panel Sets horizontal position of the
vertical cursor lines
V Position (2)Top Panel Sets vertical position of the
horizontal cursor lines
Off/White/Black Top Panel Sets color of line display
Solid/Dashed Top Panel Selects solid or dashed line display
“M” option only
2/1 Line Sets Top Panel Selects 1 or two sets of lines for display
6

warranty
Colorado Video, Incorporated warrants the equipment of its manufacture to be free of defects
in material and/or workmanship under normal use and service. Colorado Video,
Incorporated’s obligation under this warranty is limited to making good at its laboratories any
part or parts thereof , which shall within one (1) year after delivery to the original purchaser
be returned to Colorado Video, Incorporated at its laboratories, with transportation charges
prepaid, and which Colorado Video, Incorporated’s examination shall disclose to its
satisfaction to have been defective.
This warranty is expressly in lieu of all other warranties and representation, express or
implied, and of all other obligations or liabilities on the part of Colorado Video, Incorporated.
In no event shall Colorado Video, Incorporated be liable for damages of any kind connected
with the use of its equipment or its failure to function properly.
This warranty shall not apply to any equipment which shall have been repaired or altered
outside of Colorado Video, Incorporated’s laboratories so as to, in Colorado Video,
Incorporated’s judgement, affect its use, function, reliability, or which shall have been subject
to misuse, alteration, improper installation, negligence, or accident.
Before any equipment is returned to Colorado Video, Incorporated for repairs or adjustments,
shipping instructions should be obtained from Colorado Video, Incorporated. Colorado
Video, Incorporated assumes no responsibility for unauthorized returns.
7