
COMFILETechnology,
Inc. www.comfiletech.com •page 4
CWA
H
/
W
M
a
n
u
a
l
CUWIN
S
e
r
i
e
s
φ2.5 DC Power Input Jack for adaptor
Power terminal for cables
COM3 (RS232C / Female Type D-SUB 9PIN)
COM2 (RS232C / Female Type D-SUB 9PIN)
COM1_RS232C (RS232C / Female Type D-SUB 9PIN)
DIP Switch for selecting COM1 mode
10Base-T Ethernet Port (RJ-45)
USB Host Port (USB A Type Connector)
USB Device Port (USB B Type Connector)
StereoAudio Output Port (φ3.5)
DIP Switch for selecting Boot mode
3. Bracket Installation
Mounting screws and brackets are provided with each CUWIN. They are designed to clamp the
CUWIN bezel against a front panel, with the rear portion of the device extending through a panel
cutout.
After assembling the brackets as shown below, insert the side hooks into the appropriate mounting
holes on the top and bottom of the device.
Then tighten the screws enough to hold the CUWIN securely against the front panel. Do not over
tighten, or you will risk damagingthe CUWIN.