COMSOL UCB-202 User manual

USER MANUAL
2 PORT USB 2.0 CARDBUS
UCB-202

2 Port USB 2.0 Cardbus User Manual Page 1
CONTENT
1. Introduction----------------------------------------------------------------------------------2
2. Product Features--------------------------------------------------------------------------2
3. Technical Specifications--------------------------------------------------------------2
4. Driver Installation-------------------------------------------------------------------------3

2 Port USB 2.0 Cardbus User Manual Page 2
1. Introduction
This PCMCIA USB 2.0 Card Bus card is compliant with the Universal Serial Bus
Specification Revision 2.0 and Open Host Controller Interface Specification for low-speed
(1.5Mbps) / full-speed (12Mbps) speed signaling and Enhanced Host Controller Interface
Specification for high-speed signaling (480Mbps).
2. Product Features
•Quick & easy installation - ideal for any mobile executive.
•Provides 2 external USB type-A ports.
•Supports transfer rate of 1.5/12/480 Mbps.
•Fully forward and backward compatible with USB 1.1.
•Supports 32 bit CardBus PC Card type II slots.
•Automatically switches to the peripheral's highest supported speed
3. Technical Specifications
Function Specification
PC Connection 2 x USB external port Type A
Transfer Rates 1.5/12/480 Mbps
OS Support Windows 98//Me/ 98SE/2000/XP
Weight 50g
Standards USB2.0
Dimensions
(L x W x H) 115.5 x 54 x 13.8 mm

2 Port USB 2.0 Cardbus User Manual Page 3
4. Installing Windows 98/98SE/ME/2000/XP driver
This PCMCIA USB 2.0 Card Bus card requires two drivers in order to function properly.
These drivers are:
1. “NEC USB Open Host Controller” drivers
For the two “NEC USB Open Host Controller”, no additional driver required. Full driver
support by Microsoft OpenHCI based drivers. Simply have your Windows O/S Installation
CD ready when Windows Installation Wizard prompts for the location of the driver.
2. “NEC PCI to USB Enhanced Host Controller” driver
For the “NEC PCI to USB Enhanced Host Controller”, the driver is located in the Driver CD
that came with the card. When Windows Installation Wizard detect this device “PCI
Universal Serial Bus”, insert the Driver CD in to the CDROM drive and go to this directory -
D:\NEC\uPD720100 (Assuming drive D is your CDROM drive) to install the driver.
After you have installed the driver, go to the Device Manager to check if you have properly
installed the driver. Under “Universal Serial Bus Controller” in Device Manager, these
items have been added.
NEC PCI to USB Enhanced Host Controller
NEC USB Open Host Controller
NEC USB Open Host Controller
USB 2.0 Root Hub Device
USB Root Hub
USB Root Hub
If you have all these items added in to the Device Manager and there is no exclamation
mark next to these items then you have install the NEC PCI to USB 2.0 Host Controller
card properly and the card is ready for use!