Connects2 CAM-WL2 User manual

- Working Frequency: 2400-2486.5 MHz
- Modulation System: BSPK.QPSK. 16-QAM
- Transmission Bandwidth: 3Mbps
- Transmitted Power: 20dBm
- Receive Sensitivity: -90dBm
- Transmission Distance: >200M
- TV System: PAL/NTSC
- Video Output: 1.0V p-p 75ohm
- Operating Voltage: 12V DC (Negative Ground)
- Current Consumption: 150mA @ 13.8V
- Operating Temperature: -10 Degrees C to +50 Degrees C
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Wireless Digital Receiver
PRODUCT FEATURES:
DISCLAIMER:
CAM-WL2

www.connects2.com
2
Connects2Vision
CONTENTS
- 1x Wireless transmitter with 0.75m cable with Female DC power connector
and Female RCA connector
- 1x Wireless receiver with 0.75m cable with Female DC power connector and
Male RCA connector
- 2x 1m DC power cable with Male DC connector
- 2x Antennas
- Instructions
INSTALLATION
Transmitter
1. Take 1x of the DC power cables and plug the Male connector into the
transmitters Female power connector. Then connect the Black wire to a
suitable ground and the Red wire to a switched +12V supply.
2. Connect the cameras video RCA connector into the Female RCA connector
on the transmitter labelled “VIDEO IN”.
3. Connect the antenna
Receiver
1. Take 1x of the DC power cables and plug the Male connector into the
transmitters Female power connector. Connect the Black wire to a suitable
ground and the Red wire to a switched +12V supply.
2. Connect the Male RCA connector from the receiver labelled “VIDEO OUT” to
the display monitor. Connect the antenna and ensure that the image from the
camera is being transmitted and displayed on the monitor.
3. During normal operation, the status LED’s on both the transmitter and
receiver will blink rapidly. If pairing of the transmitter to the receiver is required,
press the pairing button on the side of the transmitter and the status LED will
blink off and on indicating the unit is in pairing mode.
4. Now press the pairing button on the receiver within 10 seconds to complete
the pairing.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2