ConServ CRF 450 B User manual

Model - CRF 450 B / S
Compact Refrigerator
OWNER’S MANUAL
Please read the instructions carefully and keep for future reference. Information may be
updated from time to time so please refer to the manual online for the latest version of the manual.
4.5 cu.ft.

Breakage of door or shelves

2. Open Camera

5” (13cm)
Installation and Operation
The temperature control knob is located inside the refrigerator on the right side.
Turn the temperature control knob to 4, which is the normal position to keep food cold.
Wait about 4 hours for the refrigerator to be adequately cold before putting food inside.
If a slightly higher or lower temperature is preferred, the knob can be turned, with 1 being
least cold and 7 being the coldest. To make the refrigerator cool fast, turn the knob setting
to 7 and then when the level of cold is reached, turn the knob to the normal setting.
If the refrigerator is unplugged or loses power, please wait five minutes before restarting it.
If restarted before this time delay, the refrigerator won't start.
Temperature control knob
Temperature Setting
Interior light
Place the unit on flat and stable ground. Keep the unit level by adjusting the feet.
Place the unit in a well ventilated and dry environment.
1
0
7

Remove the light cover to replace the bulb and ensure that
the replacement bulb is the same size and wattage.
Technical Specifications
Model
Capacity
Voltage
Current
Refrigerant
Net Weight
Product Dimensions (HxWxD)
CRF 450 B/S
4.50 cu ft
115V 60Hz
1.1A
R600a
59.5 lbs
46.5 x 21.6 x 22.5 (inch)
It is recommended that the appliance is manually defrosted every 3 months or when there
is a build up of ice in the freezer. Turn off the appliance by turning the temperature knob
setting to 0. Remove all items and leave the refrigerator door closed, but keep the freezer
door open to allow the ice to melt. The ice and water can be collected in a drain pan.
Defrosting
Do not use mechanical devices or hot water to accelerate the defrosting process. The
normal process will take a few hours. Wipe down the appliance and wait for 2 hours before
starting it again. Turn the temperature knob to the desired setting.
bulb
the
s

Door Reversal
1. Unplug the appliance.
2. Remove the 2 plug buttons on the top of the unit.
3. Remove the plastic hinge cover by lifting from the back and
pulling forward.
4. Remove the 2 screws from the top hinge.
5. Lift the freezer door up off the center hinge. Place the freezer
door on a flat surface with the outer surface facing up, as not
to damage the door.
6. Open the refrigerator door and remove the 2 screws attaching
the center hinge. Remove the center hinge.
7. Lift the refrigerator door up off the bottom hinge. Place the
refrigerator door on a flat surface with the outer surface
facing up, as not to damage the door.
8. Tilt the appliance back to remove the 3 screws attaching the
bottom hinge. Remove the bottom hinge.
9. Remove the hinge pin from the bottom hinge and reinstall on
the opposite side of the hinge.
10. Reinstall the refrigerator door and then freezer door on the
opposite side, using the parts that have been removed.
The doors in this appliance can be reversed, so that they swing open in the opposite
direction. To reverse the doors, please follow the instructions below.