Contro l4 C4-DIN-8REL-E-V2 User manual

8-Channel Relay
Wiring Guide
Supported model
• C4-DIN-8REL-E-V2 8-Channel Relay
Diagrams color code*:
Black Line
Red Load
Grey Neutral
Green Earth ground
Blue Ethernet
*Important! The wire colors shown in Figures 1 and 2 and in the
“Diagrams color code” table are examples only. Actual wire colors dier
by country and/or voltage.
Wiring diagrams
Use these Control4 8-Channel Relay wiring diagrams along with the 8-Channel
Relay Installation Guide ( ctrl4.co/8chrelay-ig ) to install 8-Channel Relays.
Figure 1. Wiring in Control4 panel
To Ethernet switch
Only Load 1 shown in detail
All Line-Ins MUST be the same phase
Distribution
(breaker)
panel
Override switch
Load 1
Load 2
Line 1
Neutral Out 1
Neutral Out 2
Neutral In 1
Aux Override In
Aux Override Out
Ground
Load 3
Load 4
Line 2
Load 5
Load 6
Line 3
Load 7
Load 8
Line 4
Neutral Out 3
Neutral Out 4
Neutral In 2
Neutral Out 5
Neutral Out 6
Neutral In 3
Neutral Out 7
Neutral Out 8
Neutral In 4
Terminal block
Important: Remove the four bypass
jumpers that connect each black
terminal to two red terminals by
unscrewing all three screws in each
bypass jumper until the entire bypass
jumper can be pulled out.
Load 3
Load 4
Load 5
Load 6
Load 7
Load 8
Load 1
Load 2
Neutral 1
Line 1
Neutral 2
Line 2
Neutral 3
Line 3
Neutral 4
Line 4
Aux in
Aux out
C4-DIN-8REL-E-V2 8-Channel Relay
ATTENTION: Risque de choc électrique Ne pas ouvrir
This device complies with part 15 of the FCC rules and ISED’s license-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (B)/NMB-3(B)
100-120V 50/60 HZ 64A Max Total 16A Max Per Circuit 16A Max Per Channel 1 HP Max Per Channel @ 120V Refer to documentation for load ratings
LISTED E501121 Ind. Cont. Eq.
Made in China/Fabriqué en Chine/中国制造

control4.com | 888.400.4070
Copyright ©2018, Control4 Corporation. All rights reserved. Control4, the Control4
logo, the 4-ball logo, Control4 My Home, and Mockupancy are registered trademarks
or trademarks of Control4 Corporation or its subsidiaries in the United States and/or
other countries. All other names and brands may be claimed as the property of their
respective owners. All specifications subject to change without notice.
Figure 2. Wiring in standard DIN rail panel
200-00509-B.3
2018-10-11 LW
B
To Ethernet switch
Distribution
(breaker)
panel
Load 3 Load 4 Load 5 Load 6 Load 7 Load 8 Load 1 Load 2
Neutral 1 Line 1 Neutral 2 Line 2 Neutral 3 Line 3 Neutral 4 Line 4
Aux in Aux out
C4-DIN-8REL-E-V2
8-Channel Relay
ATTENTION: Risque de choc électrique Ne pas ouvrir
This device complies with part 15 of the FCC rules and ISED’s license-ex-
empt RSSs. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
CAN ICES-3 (B)/NMB-3(B)
100-120V
50/60 HZ
64A Max Total
16A Max Per Circuit
16A Max Per Channel
1 HP Max Per Channel @ 120V
Refer to documentation
for load ratings
LISTED
E501121
Ind. Cont. Eq.
Made in China/Fabriqué en Chine/中国制造