Cordless Steam Iron 10987 Instructions for Use
Please read and retain these instructions for future reference v001: 02/10/17
STEAM IRONING
Place the iron in a vertical position and set the temperature control dial at the minimum/low heat setting
as in above table.
Insert the plug into the socket, and then turn the temperature control dial to the desired heat marking.
The indicator light will come on, showing that the iron is heating up.
When the indicator light turns off, the set temperature has been reached and the iron is ready to use.
During ironing, the indicator light on the iron automatically switches on/off as the thermostat maintains
the set temperature (you may continue ironing during this process).
Turn the steam control turning knob to the required position.
Steam is produced as soon as the iron is held horizontally.
SPRAYING
Press the spray button to spray water on clothes, as often as required.
Note: When using the water spray function, ensure that there is enough water in the water tank. You may
have to pump the spray button several times the first time you use the iron in order to start the spraying
function.
BURST OR VERTICAL STEAM IRONING
Press the burst of steam button to generate a powerful burst of steam that can penetrate the fabric and
smooth the most difficult and tough creases. Wait for a few seconds before pressing again.
By pressing the burst of steam button at intervals you can also iron vertically (curtains, hung garments,
etc.)
Note: The burst steam function can only be used at a high temperature. Stop the emission when the
indicator light turns on, then start ironing again only after the indicator light has turned off.
DRY IRONING
For ironing without steam, follow the instruction in section “steam ironing”, however, the steam control
turning knob should remain in the “OFF”position (no steam).
HOW TO CLEAN AND STORE
After use empty the remaining water from the water tank.
Insert the plug into the main socket, and set the temperature control dial to “MAX” for 1-2 minutes to
evaporate the remaining water, and then unplug the iron and let it cool down before storing it.
