Coppernic C-five User manual

C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20
| Non-Contractual Pictures |

SAFETY PRECAUTIONS
Page 02 | 13
•Before entering in hazardous location, the device shall be inspected for signs of damage on the enclosure.
•If damages are visible do not use the device in hazardous locations until it is repaired by an authorized service center.
•The housing of the device must not be opened inside the Ex-hazardous area.
•Charging and wired data connection is only allowed in safe (non-hazardous) locations.
•It is only allowed to exchange the battery pack in safe (non-hazardous) locations.
•The device may only be used with battery pack type BP16-001510.
•The device may be used without handstrap, screen protector or carry case.
•Only protective case and handstrap allowed to use:PN 6070-000110 purchased to COPPERNIC.
•Usage only in controlled environment with suitably reduced pollution.
•The device shall be protected against excessive UV-light.
•The device shall be protected against mechanical impacts with high impact energy.
•The device shall never be used next to strong charge generating processes.
•The device shall not be attached with ascreen protector.
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20

WHAT'S IN THE BOX ?
C-five
C-five ATEX
Page 03 | 13
1
2
3
123
45
6 7 89
DEVICE
NOTICE
BOX
4
5
6
PLUGS : UK or EU
(VARIES BY CONFIGURATION)
CABLE MICRO USB | USB A
POWER SUPPLY
7
8
9
BATTERY
PROTECTIVE CASE & HANDSTRAP
(ACCESSORY IN OPTION)
TEST REPORT
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20

PRODUCT OVERVIEW
| Non-Contractual Pictures |
C-five
C-five ATEX
Page 04 | 13
2D imager
led indicators
5’’ touch panel
volume keys +/-
function key
SCAN | KEY RIGHT
(P3)
menu keys
RETURN | HOME | DATA
power key
function key
KEY LEFT UP
(P1)
function key
SCAN | KEY LEFT DOWN
(P2)
micro USB
pogo connectors for charging
battery latch
battery door
led flash camera
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20

Setting up your device
IMPORTANT WARNING
•The Micro SIM must be inserted parallel to the battery compartment.If not, there is arisk to damage the SIM connector.
•Please ONLY use regular Micro SIM card provided by the carriers.Do not use aSIM adaptor tray to avoid the damage
of micro SIM slot due to an improper SIM installation (uneven surface) on atray.
MICRO SIM | MICRO SD cards installation
•Open the battery door: Slide the battery latch to the right
•Insert the Micro SD card into SD slot
•Insert Micro SIM card into SIM slot
Page 05 | 13
Micro SD card
Micro SIM card
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20

Setting up your device
Battery installation
•Insert the battery, top side first.
•Rotate the bottom side of the battery in the compartment.
•Press down the battery cover until you hear a “click” sound.
Page 06 | 13
NOTE
Please make sure the battery latch is on the left hand side for the battery door to close properly.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO
THE INSTRUCTIONS.
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20

Page 07 | 13
Setting up your device
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20
CAUTION
Please make sure the device being charged fully when using C-five at first time.
Please ensure the Micro USB port clean and dry before inserting aUSB cable for charging to avoid the operating issues on the device.
Please remove water or moisture from the Micro USB port instantly with soft cloth when the device gets wet, to avoid the
operating issues on the device.
Charge the BATTERY
Before using the C-five, please charge the battery using one of the following accessories approved by COPPERNIC.
1. Insert the micro USB cable into the C-five and USB Acable into the power supply.
> Cable Micro USB | USB A is included in the device box.
> Power supply is included in the device box.
2. Insert the Jack Power Adapter into the docking station and the power supply into the socket.
> Power supply is included in the docking station box.
BACK VIEW

Setting up your device
LED indicators
Red LED blinks (LED1)
Low battery
Red LED (LED1)
Battery is charging
Green LED (LED1)
Battery is fully charged
Blue LED blinks (LED2)
BT devices connected or receiving messages/notifications
Page 08 | 13
CRADLE: DS-FIVE
LED indicates the status of cradle power connection and battery power.
DEVICE: C-FIVE
Red LED
Power connected and low battery power
Green LED (LED1)
Power connected and battery fully charged
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20

Using your device
TURNING ON | TURNING OFF your device
Power Off | Press and hold during 5 sec. the power button and select “Power off” in the
dialog box.
Reboot | Press and hold during 5 sec. the power button and select “Reboot” in the dialog
window to restart the device.
Suspend Mode | Press and release the power button to place the device in suspend
mode. The display will be off and go into a low power state to conserve battery power.
Reset | Press and hold the power button during 30s.
Page 09 | 13
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20

Using your device
DATA CAPTURE | photos & videos
Use the rear camera to take photos and capture video.
1. Go to Home Screen > select “Camera” > Tap camera icon or screen to take a picture/switch to video icon and tap for
video recording.
2. Using the rear camera to take photos and capture video.
NOTE
Ensure device memory or extend Micro SD card space is available.
DATA CAPTURE | barcode scanner
CAUTION
Class 2laser when open.
Do not stare into beam or view with optical instruments.
Complies with 21cfr1040.10 and 1040.11 except for deviations pursuant to laser notice no.50,dated June
24,2007 and IEC/EN 60825-1:2014.
NOTE
Please remove the protector film before using scanner.
Scan with the imager
•Use "barcode settings" provided by Coppernic.
Side-Key Remapping for scanning
•Go to "Settings" >Select "Remap key & Shortcut"
•Select the key (KEY LEFT DOWN, KEY RIGHT: side function keys) >Tap Remap Key >Tap Barcode Scan
•The red laser aiming pattern turn on to assist in aiming, scan ready when beep sounds
•Release the scan button.
Page 10 | 13
C-five | C-five Ex
Quick Start and Regulatory Guide
QSG 180127 A20