IDC Icemaker Adapter Kit Installation Instructions
Publication Number: 629088662INS - 2 - © 2005-2010, IMI Cornelius Inc.
1. Place bar into first set of pockets inside the ice bin, gasket side up.
Figure 2.
2. Place Icemaker rail supports into pockets in the ice bin as shown in Figure 2.
3. Hook cross braces over top of bar and back of ice bin such that they fit down inside the outer pockets
of the ice bin. Place gasket side up.
4. Place Icemaker Adapter Kit on top of unit.
5. Place icemaker on top of kit. DO NOT slide icemaker into position on the lid.
6. Apply continuous bead of NSF international (NSF) listed silastic sealant (Dow 732 or equivalent),
supplied in kit, to seal the icemaker to the top of the adapter kit. All excess sealant must be wiped away
immediately.
7. The next steps discuss loading and securing the icemaker onto the kit. Please read all the following
steps to determine which mounting method should be utilized. Equally important is to determine if
there is sufficient access in the area of the mounting brackets after the dispenser is lifted onto the
counter. Access should be carefully considered before installation continues because sufficient room is
required for drilling holes, installing screws, etc.
Two options are supplied with this kit for securing the icemaker to the kit. (See Figure 3.)
Option 1: Includes two flat brackets. This method may be used if there is sufficient access to the
back of the dispenser in the areas of the mounting brackets.
Option 2: Includes two angle brackets. This method may be used if there is not sufficient access to
the back of the dispenser in the areas of the mounting brackets. Pre-drilling holes should be
considered when using this option.
Cross
Braces
Front Icemaker
Rail Support
