
• Read all the safety instructions before first use of your hairdryer.
• THIS HAIRDRYER IS LIVE UNTIL THE POWER IS DISCONNECTED AT THE MAINS. TO AVOID
RISK OF ELECTRIC SHOCK:
• Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
• When the hairdryer is used in a bathroom, unplug it after use since the proximity of water
presents a hazard even when the hairdryer is switched off.
• This appliance is not intended for use by persons(including children)with reduced physical,
sensory or mental disabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Always unplug the hairdryer after use.
• Do not use or store the hairdryer where it can come into contact with water.
• If the appliance falls into water, UNPLUG IT IMMEDIATELY. Do not reach into the water until
the power has been disconnected.
• This hairdryer should never be left unattended when plugged in.
• Do not pull or wrap power cord around the hairdryer.
• Do not use attachments not recommended by the manufacturer.
• Never operate the hairdryer if it has a damaged cord or plug or if it has been dropped into
water. Return the appliance to the service centre for examination and repair.
• Keep the cord away from heated surfaces.
• Never block the air vents at the rear of the hairdryer, or place it on a soft surface where the air
vents free of dust, hair, etc. Do not insert any objects into the air vents.
• Do not use outdoors, or where aerosol products are being used.
• Do not direct hot air toward eyes.
• Attachments may get hot in use. Please be careful when handling them.
• Do not put the hairdryer down while it is operating.
• Check that the voltage rating of this appliance matches that of your supply.
• The mains lead of this appliance is not replaceable by the user. If the supply cord of this
hairdryer is damaged it must only be replaced by an qualified engineer as special tools are required.
2