Coronado HDQ-09 User manual

Product Name: Coronado LP Fire Pit Table
DANGER
1.888.880.4884
Qindao Hichanse Group Co.,Ltd
Eastern Wenhua Road, Jimo Economic Developing
Zone, Shandong Province ,China
WARNING
Improper installation, adjustment,alteration,service or
maintenance can cause injury or property damage. Read the
installation,operating and maintenance instructions thoroughly
before installing or servicing this equipment.
WARNING An LP-cylinder not connected for use shall not be
stored in the vicinity of this or any other appliance.
WARNING
USE LIQUEFIED PETROLEUM GAS ONLY!
-Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier form a neighbor’s
phone.Follow the gas supplier’s instructions.
• If you cannot reach yous gas supplier,call the fire
department.
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
Battery may contain mercury. Do not deposit in fire or put in trash.
Recycle manage as hazardous waste.
WARNING
Turn off gas supply when the fire pit is not in use.
If the fire pit is stored indoors, leave LP-Gas cylinder outdoors.
ASSEMBLY INSTRUCTIONS
Propane cylinders sold separately
WARNING
For Outdoor Use Only!
Use Liquefied Petroleum Gas (LP-Gas) Only !
ITEM Number: ALZ651-1
READ BEFORE USE!
WARNING:
If the information in this manual is not followed exactly
,a fire or explosion may result causing property
damage,personal injury or loss of life.
DANGER If you smell gas:
1.Shut off gas to the appliance.
2.Extinguish any open flame.
3.If odor continues,keep away from the appliance and immediately
call your gas supplier or fire department
CARBON MONOXIDE HAZARD
This appliance can produce carbon
monoxide which has no odor
Using it in an enclosed space can
kill you.
Never use this appliance in an
enclosed space such as a camper,
tent, car or home.
S
I
L
D
E
T
USC
CM
Intertek
3195402
1

Outdoor Gas Fireplace
*Do not use this fire pit for cooking.
*Do not burn any other materials than are supplied with and intended for use in this fireplace.
*Do not pour water into fireplace.
*The installation of this product must conform with local codes or,in the absence of local codes,with the National Fuel Gas
Code,ANSI Z223.1.
* The pressure regulator and hose assembly provided with the fire pit must be used. The replacement must be those specified
by manufacturer.
*Do not use this fireplace if any part has been under water.Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any gas control which has been under water.
*Do not store a spare or disconnected liquefied petroleum gas cylinder under or near this fireplace.
*After a period of storage, and/or non use, the propane fireplace should be checked for gas leaks and burner obstructions
before use.
*Do not operate the propane fireplace if there is a gas leak present.
*Never use a flame to check for gas leaks.
*Combustible materials should never be within 48 feet of the top, back or sides of your propane fireplace.
*Do not put any other fireplace cover or anything flammable on, or beneath the fireplace.
*
The propane
f
ireplace should never be used by children.
C
hildren must be supervised when they are anywhere near the
a
pp
liance.
*
Users should be alerted to the hazards o
f
high sur
f
ace temperatures and keep a sa
f
e distance to avoid burning or clothing
i
g
nition.
*Cylinder supply system must be arranged for vapor withdrawal
*
Pay attention when operating the
f
ire pit. It is hot in use and should never be le
f
t unattended. Do not transit it while in
o
p
eration.
*Should fire go out while burning, turn the gas valve off. Follow the instruction and wait five minutes before attempting to relight.
*
Never use charcoal or any other solid
f
uel in the
f
ire pit. Never parch clothing or other
f
lammable materials on or near the
f
ire
p
it.
*Never lean over the open fireplace or place hands or fingers on the upper portion of an operational unit.
GENERAL INFORMATION
This fire pit complies with "ANSI Z21.97-2010, American National Standard For Outdoor Decorative Gas Appliances and CSA
CR97-003, Outdoor Gas Fireplaces". Please read this manual thoroughly to familiarize yourself with the operation and
precautions before you use this appliance.If the information in this manual is not followed exactly,a fire or explosion may result
causing property damage,personal injury or loss of life.
DANGER
Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily
injury or death, or in a fire or an explosion causing damage to property.
SPECIFICATIONS
Max. 250 PSI
1.61mm
11 inch W.C
Product Name
Model No.
Rated Heat Output
Type of Gas
Gas Supply
Gas Supply Pressure
HDQ-09
27000 btu/hr
Propane
20 lb LP-Gas Cylinder
*Keep ventilation openings in cylinder enclosure(FIREPLACE BODY) free and clear of debris.
*Do not rest feet on the fireplace.
*Please take out the battery when not using the fireplace for an extended length of time.
*Do not enlarge valve orifices or burner ports when cleaning the valve or burner.
IMPORTANT SAFETY INFORMATION AND PRECAUTIONS
Orifice Size (dia.)
Mainfold Pressure
2

ITEM DESCRIPTION QTY
A Fire Glass 1 BOX
B Battery (AAA) 1PC
C Body 1PC
D Door 1PC
E Marble 1PC
F Marble Cover 1PC
.Do not use this fireplace unless all parts are in place.
*Do not attempt to disconnect the gas regulator or any gas fitting while your fireplace is
in operation.
Expanded view
*LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications for LP-gas cylinders
of the U.S. Department of Transportation (DOT).
3. Get to your gas supplier and/or the fire department for help.
*A dented or rusty liquefied petroleum cylinder may be hazardous and should be checked by you
1. Turn off the gas supply and get away from the gas cylinder and the fire pit at once.
*The conversion or attempted use of natural gas in a liquefied petroleum gas unit or liquefied petroleum gas in a natural gas
unit is dangerous.
*This appliance shall be used only outdoors in a well-ventilated space and shall not be used in a building .garage or any other
enclosed area.Do not use this fire pit on vehicles or boats. Always operate the appliance on flat ground outdoors.
*Keep any electrical supply cord and the fuel supply hose away from any heated surfaces.
2. Do not attempt to correct the problem yourself.
*Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the appliance.
*Do not burn wood or any other materials in this fire pit.
*Cylinder must be stored outdoors in a well-ventilated area out of the reach of children.
Disconnected cylinder must have threaded valve plugs tightly installed and must not be
stored in a building garage or any other enclosed area.
*If you see, smell or hear the hiss of escaping gas from the liquefied petroleum cylinder:
*Transit and store the empty gas cylinders carefully and properly.
*Do not use a liquefied petroleum cylinder with a damaged valve and any other worn out parts.
*LP Tank used must include a collar to protect the cylinder valve
*Never fill the cylinder beyond 80% full
*Liquefied petroleum gas is not natural gas. Only use propane for this fire pit.
FOR LIQUEFIED PETROLEUM GAS UNITS
*Use only 20 lb / 9.1 kg LP-Gas cylinders.
1PC1BOX
A
D
1PC 1PC
C
B
1PC1PC
E
F
3

No. Part Description
1 Body
2 Door
3 Burner
4 Fire Bowl
5 Heat Insulation Board
6 Ignition Pin
7 Thermocouple
8 Control Valve
9 Pulse Ignition
10 knob
11 Regulator
12 Guard
13 Grounding Wire
14 Granite top
15 M8*30 Wing Screw
16 Granite top cover
17 M4 Hex bolt
18 M4 Nut
19 connecting tube
20 Nozzle
(2) After removing the carton, knocked on the wooden frame at the top carefully, remove the marble on the side.
HDQ-09-18
HDQ-09-10
HDQ-09-11
HDQ-09-12
HDQ-09-13
HDQ-09-06
HDQ-09-07
8
1
1
1 HDQ-09-14
HDQ-09-15
HDQ-09-16
1
1
HDQ-09-19
HDQ-09-20
STEP 1.
(1) Cut the ties on the carton, the carton up and out.
HDQ-09-09
1
1
1
1
HDQ-09-17
6
* Please keep these assembly instructions for future reference.
1
1
1
HDQ-09-03
1 HDQ-09-04
1
HDQ-09-05
HDQ-09-08
1
QTY Part No.
HDQ-09-01
HDQ-09-021
ASSEMBLY INSTRUCTIONS
1
STEP 2. (1) Place the firepit on a flat ground.
(2) The marble is installed on the top of the firepit.
(3) Cut off the tie fastened the regulator at the metal stand and set
it free for installation to LP-Gas Tank.
Parts/hardware List
1
(3) Marble removed, carefully knock the wooden frame, remove the product and marble cover, a box of fire glass
STEP 2
S T E P 1
4

STEP 3.
(I) Check each part before using the product. Make sure
the gas supply system is turned "OFF" before assembling.
(See Figure I.)
(II)Put the gas tank on the metal stand. Make sure the gas
tank sits on the metal stand completely. Turn the wing
screw on the outer part of metal stand clockwise to secure
the gas tank tightly. (See Figure II. )
(III) Make sure the hose is secured in retainer clip. Connect
the regulator to the gas tank.(See Figure IV.)
1) Turn the T-handle clockwise to close the gas supply on
the gas tank.
2) Screw Regulator Coupling clockwise by hand only. Make
sure it is fastened.
(IV) Place the fireglass averagely in the fire bowl on the top
of the fire pit. Otherwise the firepit can not be operated
properly. (See Figure V )
STEP 4. LEAK TEST
●If the appliance is not in use,the gas must be turn off at the supply cylinder.
WARNING
●Do not use an open flame to check for leaks.
TIPS: Before Beginning ●Read the instructions thoroughly.
●Check and make sure that all parts are present.
●Do not smoke during testing.
●Do not test indoors.
●A leak check must be performed whenever the gas cylinder is replaced.
2. Make sure the gas cylinder is correctly and securely connected to the pressure regulator, without over tightening it.
3. Turn on the gas cylinder valve. Apply 50% soap and 50% water solution to the gas hose and connections between the
control knob and gas cylinder.
4. If something is leaking, you will see bubbles form. In case of leaks, turn off the gas supply, undo the leaking connection, re-
connect and try again. If the leak persists, consult Sunjoy Industries Customer Service Center for assistance.
●For future reference, save this instruction sheet.
1. Make sure the control knob is on the “OFF” position.
This screen must be clear and free of obstructions
at all times to insure proper operation.
WARNING
** DO NOT COVER THE IGNITION SCREEN when placing the fireglass into the fire bowl. Always keep Ignition Screen
visible.
Ⅲ
Ⅰ
ⅠⅠ
Ⅴ
Do not place the
fire glass on the
screen, keeping
the screen visible
Screen
5

※Push the Control Knob and turn clockwise to the "OFF" position.
TO LIGHT
※The propane cylinder must be disconnected and removed from the fire pit before the appliance can be stored indoors.
※Be careful not to let any powder or solvent come in contact with painted or plastic components as damage may occur.
※After the burner and lava rocks are completely cooled down, use a soft brush to get rid of the mild stains,loose dirt and soil.
Wipe with a soft cloth.
※Store the fire pit in a cool dry place away from direct sunlight.
※Store the gas cylinder in a dry, well-ventilated and sheltered area protected from inclement weather and dust, out of the
reach of children, and not in a building, garage or any other closed area.
※Visually inspect burner from obstructions, keep tank enclosure free and clear from debris.
※Keep your firepit free and clear from combustible materials.
※Turn the T-handle on the gas tank clockwise to close the gas supply if not for use in a long time.
※Installation and repair should be done by a qualified service person.The appliance should be inspected before use and at
least annually by a qualified service person.More frequent cleaning may be required as necessary .It is imperative that control
compartment,burners and circulating air passageways of the appliance be kept clean.
※Make sure both the gas and the fire pit are turned off before changing battery. Please refer to the process of assembling
batter
y
.
※Use Manufacturer approved or supplied replacement parts and accessories only. Otherwise may void the warranty of this
product and result in a hazardous condition.
※If replacement parts are needed, please contact Hayneedle, Inc. Customer Service Center at 1.888.880.4884
MAINTENANCE
Before each use, inspect all hose. Replace hose if there are any signs of cutting, wear or abrasion.
(1) Turn the T-handle on the gas tank counter-clockwise to open the gas supply.
(2) Light the firepit as below steps:
A. Push and turn the Control Knob counter-clockwise to the "LOW" position. Keep pushing the Control Knob. Meanwhile press
and hold the Electric Ignitor to light the burner .
B. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 15 seconds.
C. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5
minutes, then repeat the lighting procedure as above.
6