Costco Adore Li User manual

This is not a substitution for reading your Owner’s Manual. For more In depth instructions,
please refer to your Owner’s Manual.
Adore™Li
Quick Start Guide
RX 18815 Rev. 8/2018 PN 10240643 1.0
Consult your Hearing Care Professional if you have further problems.
Troubleshooting
Problem & Possible Solutions
Sound is weak:
Hearing aid does not work:
Hearing aid emits whistling sounds:
Sound is distorted:
Hearing instrument emits spontaneous signal tones:
Increase the volume
Recharge the hearing aid
Clean or exchange the click dome or wax protector
Turn the hearing aid on
Recharge the hearing aid
Power-on-delay is active. Wait several seconds and check again
Clean or exchange the click dome or wax protector
Reinsert the receiver until it fits securely
Decrease the volume
Clean or exchange the click dome or wax protector
Decrease the volume
Recharge the hearing aid
Clean or exchange the click dome or wax protector
Recharge the hearing aid

LED Charging status
Single orange LED: Charging status 0 ‑ 33 %
Two orange LEDs: Charging status 34 % ‑ 66 %
Three orange LEDs: Charging status 67 % ‑ 99 %
Three green LEDs: Hearing instrument is
fully charged.
2. Turn Your Hearing Aids On
• Your hearing aids turn on automatically when removed from the charger
• They are programmed to have a start-up delay to allow you to insert
without whistling
• You will hear a melody during the start-up
6 Second 18 Second
3. Insert Your Hearing Aids
• Grasp receiver/dome between your thumb and forefinger
- Insert dome into your ear canal
- Gently work dome into proper position by slightly
adjusting it until it is firmly seated in your ear
• Lift the hearing aid over the top of your ear
− Adjust it to fit behind your ear
− Press slightly for a secure and comfortable fit
− Place retention strand into the bottom “bowl” of
your ear (if applicable)
1. Check the charging status of your hearing aid 4. Using Your Hearing Aids
• Your hearing aids feature Wireless Sync, which automatically adjusts both
hearing aids simultaneously to reflect changes in your hearing environment.
• The pushbutton control on your hearing aids may be programmed to give you
personal control of your hearing aids.
• The functions for short and medium press will change both hearing aids
simultaneously.
Your hearing aids may be programmed to alert you when you are making
changes to your hearing aids or when your battery needs replacing.
*Press and hold until hearing aid turns on/off
YOUR CONTROLS PRESS
Short
1 second
Medium
2 seconds Hold*
L R L R L R
Volume Up   
Volume Down   
Program Up   
TV Stream   
Airplane Mode 
Power On/Off 
SIGNAL TONES
L R
Program Change 
Volume Change 
Volume Limit 
Volume On Position 
Low Battery 
Bluetooth On/Off 
Power On/Off 
12 Second