Costume Specialists Nutcracker User manual

Wearing Instructions For
Nutcracker
qThis Costume is designed to be worn by someone of an average
build and approximately 5’4” to 5’8” tall.
qThe wearer ought to be of reasonable strength and stamina.
qT-shirt and shorts are best worn under the Costume. It’s advisable
that the wearer drink plenty of liquids before and after the event.
qThe Costume must be worn WITH shoes.
qBe sure to have a dress rehearsal. It takes two people about 10 to
15 minutes to put on the Costume. Becoming comfortable in the
Costume before the event will insure the best performance.
qHave Fun!!
This is
Nutcracker
fully assembled.
If you have
any questions or
problems please call
Costume Specialists
at
1-800-596-9357
USA
M
a
d
e
i
n
t
h
e

Wearing Instructions For
Nutcracker
This is
Nutcracker
Parts List
Body w/aached Belt
Shoe Bases
2 BSC Fans(located in
the Body)
Electrical Backpack w/
Frame Extension Pipes
2 Endura Baeries and
VL-2 Charger
ADDITIONAL ITEMS NOT
PICTURED:
• V-Mount(locatedin
ElectricalBackpack)
• Y-Cable(locatedinBody)
• WaistSnapHoop
(locatedinBody)
• Setof3SupportStraps
(aachedtoWaistHoop)
• 1DustBags
• 2ShoeBags
• ChargerBag
• CleaningInstructions
• ShippingTrunk
Frame Extension

4Reach into the Costume leg and
nd the elastic cuff.
Step foot into the cuff
so that the top elastic
sits at the knee, and
the bottom elastic is
secure at the ankle.
5Inside the Costume are three Support Straps
attached to a Hoop below
the zipper. Clip the two
front straps to the clips at
the top of the Backpack
on the side.
Clip the back Support
Strap to the top of the
Backpack at the center.
This will help support the
weight of the Costume
while the Shoe Bases are
put on.
1Check the Inventory. Make sure the
Batteries are fully
charged.
On the side of the
Battery is a button; press
to indicates how much
life is left in the Battery.
3Put on Backpack. Clip the Belt at the
wearers waist. Adjust
Belt around waist for
a snug t.
2Insert a fully charged Battery
into the V-mount Plate.
Slide the Battery into
the pocket on the
back of the Backpack.
Fasten the bag closed,
allowing the Power
Cord to hang out of the
right side of the bag.
Wearing Instructions For
Nutcracker
6Place the wearer’s foot into the
Shoe Base. Secure
the wearer’s shoe in
the sandal with the
velcro.

8Insert Frame
Extension into pipes
on back of Backpack.
Use the Pins on the
sides of the pipes to
raise the Frame Exten-
sion. This controls the
height and visibility of
the Costume. This may
have to be readjusted
after ination.
Wearing Instructions For
Nutcracker
11Adjust the straps to achieve
appropriate height and
visibility. This may
have to be done once
the Costume is on and
inated.
7Attach the velcro on the Shoe Base
to the velcro on the
Costume, making sure
to line up the center
front and the center
back. This should be a
snug t.
9Pull the Costume over the wearer
and Backpack.
Slide Backpack off
shoulders to t through
the opening of the
Costume. Once inside
the Costume, put
Backpack on and clip
belt. Adjust belt to t
comfortably, (shown in
step #3).
10While inside the Costume,
velcro the top of the
Frame Extension to
the velcro tabs inside
the top of the Bodies
Head.
12Plug the Power Cord on the
Backpack into the
Y-Cable. The Fans
should begin to run.

Wearing Instructions For
Nutcracker
Once the costume is inated, have the wearer check the visibility.
The best visibility can be achieved by adjusting the length of the Support
Straps.
If the viewing area is too low, shorten the Support Straps which will raise
the viewing area.
If the viewing is too high, lengthen the Support Straps which will drop the
viewing area.
The Frame Extension should be raised and lowered, with the adjustments
of the Suppport Straps, by moving the pegs up and down the Pipes.
BUT the weight of the Body should not be held by the Frame Extension.
13Zip Costume closed. Put on
the Belt and let the
Costume inate.
Ination takes approxi-
mately 45 seconds.
14The Nutcracker in
Red is now ready to
entertain!