
4
www.costway.com
5
Welcome to visit our website and purchase our quality products!
Reward Points
Exclusive Customer Service
Personalized Recommendaons
Permanent Shopping Cart
Order History
We would like to extend our hearelt thanks to
all of our customers for taking me to assemble
this product and giving us valuable feedbacks.
www.costway.com
Your suggestions and comments for COSTWAY are really important to us!
We sincerely solicit you to go back to our shop and leave a good rating in just a
simple click. It would be quite encouraging if you could kindly do so like below:
February 24, 2019
Great products so far. Fast delivery, easy setup, and working without any issues.
Great products so far
With your inspiring rating, COSTWAY will be more consistent to offer you
EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE!
US office: Fontana, California
UK office: Ipswich
www.costway.com
Assembly Instructions:
Read ainformation imcluaded on page 1T pefore beginning operation or installation.
1.Insert the narrow end of a T-handle into a mounting base, aligning the holes. Fasten in place
with an allen head bolt and lock nut,
2.Place an extension bar into each open end on the T-handle, passing the push pins on the
extension bar through the holes in the T-handle.
3.Repeat for the second storage rack.
Installation Instructions Using Ceiling Joists:
1. Locate the position of a ceiling joist in the desired mounting location. Place the mounting
base of the rack against the ceiling at the joist and mark the location of the mounting holes.
Remove the mounting base.
2. Check the location of each mounting hole mark to ensure there is no wiring or other
obstructions at these locations
3. Realign the mounting base with the marked mounting hole locations. Insert an allen head
screw through each
of the mounting holes and drive each screw into the ceiling joist until tight, being careful
not to strip the hole.
Installation Instructions Using Drywall Anchors:
1. Locate the desired position for the each end of the mounting rack. Place the mounting
base of the rack against the ceiling in the desired location and mark the location of the
mounting holes. Remove the mounting base.
2. Drill a 3/8”pilot hole at each of the marked mounting hole locations, being careful to avoid
drilling through wiring or other obstructions.
3. Insert a dry wall anchor into each hole, tapping them in until they are flush with the
mounting surface,
4. Place an allen head screw through each of the mounting holes in the mounting base and
align them with the wall anchors. Drive each screw into the dry wall anchor until tight, being
careful not to strip the hole.