Costway TW10053 User manual

Kid’s Trampoline
TW10053
USER’S MANUAL
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
EN DE FR ES IT PL

Before You Start
General Warnings:
The product must be installed and used under the supervision of an adult.
Read through each step carefully and follow the proper order.
Remove all packaging, separate and count all parts and hardware.
Please ensure that all parts are correctly installed, incorrect installation can lead to a
danger.
We recommend that, where possible, all items are assembled near the area in
which they will be placed in use, to avoid moving the product unnecessarily once
assembled.
Ensure a secure surface during installation, and place the product always on a flat,
steady and stable surface.
Please check and maintain it regularly, and the most important part needs to be
suspended, fixed, or anchored to the ground.
Warnings:
Attention: For home use only.
Attention: The product is not suitable for the children under 3 years
Danger: Keep all small parts and packaging materials for this product away from
babies and children, otherwise they may pose a choking hazard.
Danger: Lack of attachment may cause a risk of tipping or falling hazard.
Please read all instructions carefully and keep it for future reference.
02

DANGER
Do not use if in a cast or have previous leg,
arm, head, neck or back injury.
NO SOMERSAULTS OR
FLIPS – PARALYSIS OR
DEATH can result if you land
on your head or neck!
No more than ONE user at a
time
Do not allow children less than three (3) years
of age to use.
READ AND SAVAE THIS INSTRUCTION FOR FUTURE
USE
ASSEMBLY INSTRUCTION
03

Remove all hard or sharp objects including
jewelry, eyeglasses, sunglasses or hairclips
before jumping.
Do not use without the consent of your
physician, if pregnant.
Daily Pre-Inspection:
>Inspect legs for proper
attachment or cracks
>Inspect netting for tears
and sagging
>Inspect for loose or
damaged springs
>Inspect mat for tears or
worn stitching
>Inspect frame for sagging
or cracks
Inspect prior to use – check that the legs are properly attached and
stable on the ground; no loose springs; mat and enclosure net are in
proper place and in good condition with no tears.
04

● Use trampoline only with mature, knowledgeable adult supervision.
● Do not attempt or allow somersaults. Landing on the head or neck can
cause serious injury, paralysis, or death, even when landing in the middle
of the mat.
● Do not allow more than one person on the trampoline. Use by more than
one person at the same time increases the chance of injury.
DANGER
● Only one user at any one time! Multiple users can cause loss of control,
collision or falls on the trampoline. This could result in serious injury to
legs, arms, back, neck or head.
● Do not use the trampoline when under the influence of alcohol, drugs or
medication, which may impair the jumper’s judgement.
● Always consult your physician before performing any kind of physical
activity.
● Do not use the trampoline if you have high blood pressure.
● Do not use the trampoline if you have a medical history of neck or back
injuries or mental or physical conditions that could cause injury.
● Do not use if the user has any broken bones (casts) or has recently been in
the hospital for extensive treatments (operations, severe wounds, stitches,
back injury or concussion).
● Do not use without the consent of your physician, if pregnant.
● Do not use the trampoline during windy conditions or if the user or the
trampoline surface is wet. These conditions can cause the user to lose
control and fall, resulting in serious injury.
DANGER
Carefully read these warnings before using this product.
Failure to follow these safety instructions can result in serious
injury or death.
Important Warnings
IMPORTANT WARNINGS
05

● The product must not be used in windy conditions as wind can cause
unexpected movement of the product. Wind can cause the trampoline to be
lifted off the ground and become airborne. This can present a danger to
individuals and to property. Winds can be especially strong in open areas,
foothills, mountains, locations subject to hurricanes and tornadoes, areas
between homes that create wind tunnels and anywhere else where local
weather conditions can create high winds. We recommend that you anchor
the trampoline or otherwise secure the trampoline to prevent it from
moving as a result of the wind. One possible way to anchor the trampoline
is to secure the trampoline to a concrete footing under each leg. We
recommend consulting a local qualified technician to best determine how
the anchor system should be constructed for your specific conditions. The
qualified technician can also advise you of other options such as below
ground installation. Even with anchors, a trampoline can be lifted, just like
anything else, by strong winds. If the winds are anticipated to be very
strong, the trampoline should be disassembled and stored away safely until
the weather conditions improve.
● Always use the product in a well-lit area. Do not use without lighting during
dawn, dusk or in complete darkness!
● The trampoline must be placed on a surface that is COMPLETELY FLAT AND
LEVEL. If the ground is uneven, this could cause movement in the frame
and could cause stress on the joined sections of the frame that could
damage the trampoline and/or can cause serious injury.
● DO NOT install or position this trampoline on a hard surface such as
concrete, tarmac or paving. Suitable surfaces are grass, sand or a play area
covered with an appropriate depth of play bark material.
● ALWAYS ensure the trampoline is on level ground with a minimum of 6.6ft (
2 metres ) clear space from any structure or obstruction such as fence,
garage, house, overhanging branches, laundry lines or electrical wires.
● Adequate overhead clearance is essential. A minimum of 26.25 ft (8
metres) from ground level is recommended. Provide clearance for wires,
tree limbs, and other possible hazards.
● Do not use the trampoline indoors, as this product is intended for outdoor
home use only.
WARNING
Proper Play Conditions:
06

● Trampolines are rebounding devices, which propel the user to
unaccustomed heights, and into a variety of body movements. Rebounding
off of the trampoline, striking the frame or springs, or improperly landing
on the trampoline mat may cause serious injury.
● Do NOT use the trampoline as a springboard to jump onto other objects.
● Remove all objects not designed for use with the trampoline from the
trampoline before use. Do not let children take toys or other items onto the
trampoline.
● Do not eat while jumping.
● The trampoline should not be buried or sunken into the ground.
● During winter period, the snow load and the very low temperature can
damage the trampoline. It is recommended to remove the snow and store
the mat and the enclosure indoor.
Appropriate Use Conditions:
07

TRAMPOLINE AND ENCLOSURE PARTS LIST
Trampoline
Trampoline Mat,
Stitched with
Triangle-Rings and
Frame Pad
Top Rail Corner Top Rail with
Socket
1
x1
2
x6
3
x6
Vertical Leg Extension Plastic Vertical Leg
Extension
Plastic Horizontal Leg
Base
4
x6
5
x6
6
x3
Galvanized Spring Spring Loading Tool
8
x36
9
x1
08
Enclosure Netting
7
x1

Enclosure
Curve Frame Tube
with Foam
Top Frame Tube with
Foam
10
x6
11
x3
Hardware Parts List
Bolt Arc Washer Spring Lock Washer
x6
A B C
x12 x6
Self-Locking Screw Cap Nut Allen Wrench
x6
D E F
x6 x1
Box Wrench
x1
G
09

Flat Side
Assembly and Installation Instructions
BEFORE YOU BEGIN: Review all steps before assembly and read all
precautions before using the trampoline.
At least two adults are required to assemble this trampoline. Protective
gloves should be used during assembly to avoid pinching by the springs.
Goggles should be worn to avoid injuries to the eyes.
The assembled parts will be hereinafter referred to as “Leg Support”. Repeat
this step for all three sets of Leg Support.
NOTE: Make sure the warning label on the Leg Support faces outward.
Step 1 – Leg Support Assembly
● Insert Vertical Leg Extension (# 4) through Plastic Horizontal Leg Base (#
6) and Plastic Vertical Leg Extension (# 5).
● Make sure the hole at the top of #4 can properly align with the enclosure
tube in Step 4.
FIGURE 1
10

Step 2 – Frame Assembly
Lay out all frame parts on dry flat surface as shown in FIGURE 2. The holes
on the steel tubing parts are for installing springs and must all face up.
FIGURE 2
WARNING
Make sure that you have plenty of space and a clean dry area suitable for the
assembly of this trampoline. It should be assembled where the trampoline is
to be used. The trampoline can become unstable if it is moved after it is
assembled. IT IS ESSENTIAL THAT THE INTENDED SITE FOR
THIS TRAMPOLINE IS COMPLETELY FLAT AND LEVEL. If the
ground is uneven, this could cause movement in the frame and could cause
stress on the joined sections of the frame that could damage the trampoline
and/or can cause serious injury.
Leg Support
2
2
2
2
2
6 6
6
5
55
5
5
52
3
3
3
3
3
3
11

STEP 3
Attach Corner Top Rails with Sockets (#3) to both ends of Top Rail (#2).
Insert this entire piece into Vertical Leg Extension (#5). Repeat this process
for all three Leg Supports.
FIGURE 3
12

STEP 4
At this point, two people will be needed to assemble the trampoline.
Insert Curve Frame Tube with Foam (#10) into Corner Top Rails with Sockets
(#3). Align the holes and secure them together using Screw (#A), 2 Arc
Washer (#B), Spring Lock Washer (#C), and Cap Nut (#E).
Repeat this process for all Leg Supports.
Note: Now refer back to Step 1 and securely fasten the Plastic Flat Plate at
the bottom of the Leg Supports all the way.
FIGURE 4
10
10
10
10
10
10
10 10
13

STEP 5
Insert Top Rail (#2) between Top Rail with Sockets (#3) to form the
trampoline frame as shown below.
FIGURE 5
14

Trampoline Mat Assembly
STEP 6
Remove the foam from Curve Frame Tube with Foam (#10) and pass the
Trampoline Mat Stitched with Triangle-Rings and Frame Pad (#1) through the
tubes as shown in Figure 6. Make sure the Frame Pad faces up and fully
covers the trampoline frame. Place the foam back onto the tubes when
finished.
10
10
10
10
10
FIGURE 6
15

STEP 7
Starting at point “one”, hook one end of Spring (#8) into the Triangle-Ring on
the mat (#1). Holding Spring Loading Tool (#9) under hand, pull the other
end of the spring and lock it into the corresponding hole on the rail as shown
in FIGURE 7. Note: the two ends of the spring are different. Make sure to
install the correct ends to the mat and rail as shown below.
After you have secured the spring at point “1”, attach springs to all Corner
Top Rails (# 3) as shown in FIGURE 8. For even distribution of spring tension
and ease of assembly, the springs must always be installed on opposite sides
of the mat in an alternating manner, i.e. 1, 36 followed by 18, 19; 6, 7
followed by 24, 25; 12, 13 followed by 30, 31 as shown.
Hint: Tap on the Spring (# 8) with the handle of the Spring Loading Tool to
make sure it is securely latched into the hole on the rail.
WARNING
When attaching the springs, do not place your hands, arms, legs or any other
body part close to the connector points (i.e. joints connecting the steel
tubes). The connector points can become pinch points as the trampoline
springs tighten up. Wear heavy duty working gloves to protect your hands
from pinching by the springs and protective goggles to avoid injuries to the
eyes. Be steady when installing the springs as it can rebound and fly off if
you inadvertently let go when not hooked properly. Make sure no children are
playing nearby when installing the trampoline.
Mat
Rail
FIGURE 7
16

Step 8 – Spring Assembly
Attach two more springs in the midpoint between the corner rails. For even
distribution of tension and ease of assembly, the springs must be placed on
opposite sides of the mat in an alternating manner, i.e. 3,4 then 21,22.
Continue in this manner until all the springs are installed as shown in FIGURE 8.
Step 9 – Spring Assembly
Continue to attach all remaining springs in the same manner as before.
FIGURE 9
FIGURE 8
17

Step 10
Straighten out the frame pad (Stitched to the Trampoline Mat) so the springs
and steel frame are fully covered.
Pull the elastic straps tightly around the frame, then tie it into a one-sided
bow as shown in FIGURE 10.
Repeat this step for all of the elastic straps.
WARNING
Never use the trampoline without the frame pad. The frame pad reduces the
risk of getting injured by hitting the metal frame or springs. Inspect the
frame pad before each and every use to ensure all exposed metal parts are
fully covered!
FIGURE 10
Frame Pad Assembly
18

Step 11
Attach Curve Frame Tube with Foam (# 10) to Top Frame Tube with Foam (#
11) to form an “ARCH” as shown in FIGURE 11. Secure using the Self-Locking
Screw (# D). Repeat this step for all three sets of ARCH.
Step 12
Pull down the enclosure netting so it evenly wraps around the outside of the
ARCH and completely covers the trampoline.
FIGURE 12
FIGURE 11
7
10 10
10
10
10
10
11 11
11
11
10
7 7
19

Step 13
Tie all elastic straps on Enclosure Netting (# 7) to the frame as shown.
FIGURE 13
20
7