
4 5
COWON CX5
Dual mode
Single mode
+ Using the Product _ Pairing & connection
1. When both earphones are removed at the same time from the charging
cradle, they will automatically turn on , connect to each other, and enter
pairing mode following an audible beep.
2. Turn on Bluetooth on your smartphone or Bluetooth-capable device,
and select ‘CX5 Bluetooth L’ from the list of detected devices to pair and
connect automatically.
*To use Dual Mode, both the left and right earphones must be turned on.
1. Pair the CX5 in Dual Mode as previously shown.
2. Turn off both the left and right earphones.
3. Press and hold the button on the right earphone for 6 seconds to
enter pairing mode for only the right earphone. Pair the detected right
earphone(CX5 Bluetooth R) to your smartphone.
You can now turn on and use only the desired unit.
*In Dual Mode, L unit connects to your smartphone.
*By using the CX5 in Single Mode, you can alternate between charging the
left and right earphones for extended use. (Audio books, Podcasts, etc.)
*Since Single Mode uses only one earphone, you can stay aware of
environmental sounds and use the device more safely when walking or
bicycling.
After the initial pairing, the CX5 and your smartphone will connect
automatically when the CX5 is on and Bluetooth is enabled on
your phone.
Dual mode : The CX5’s left and right earphones can be used together in
stereo.
Single mode : The CX5’s left and right earphones can be used individually
in mono.
*Use one of the following methods to switch from Single Mode to Dual Mode.
- Press the multifunction button on the earphone that is not connected and
wait briefly to switch to Dual Mode.
- Turn off both units, then turn them on again (power cycling). Connect the
units in Dual Mode.
*Keep the product and a mobile phone within 1 meter when pairing.
*If passkey input is required, enter a password or a PIN No. ‘0000’.
*When the CX5 is off, press and hold the multifunction button for 6 seconds to
enter pairing mode.
*When powered on, the earphones will automatically connect to the most
recently connected devices.
+
LR
LR
LED flashes alternately
white and blue
Off