Creative Play ONE-20 User manual

ONE-20 BENCH
Assembly Instructions
IMPORTANT - If foundation are required support legs will be have been extended 450mm
REF: CP052/OT - ONE-20 BENCH
pg 1 of 7

REF: CP052/OT - ONE-20 BENCH
pg 2 of 7
PARTS required
BENCH SLATS - QTY 3 (120mm x 90mm)
BENCH SUPPORTS - QTY 6 (120mm x 90mm)
x2 (angle cleats/brackets)
T1
T2
x4 (PAIRS of 90x90 L’s -
NO BACK VERSION)
OPTIONAL - If installed onto tarmac/concrete
NOT REQUIRED IF SUPPORT POSTS HAVE BEEN EXENDED FOR FOUNDATIONS
x20 (180mm brass screws)
x2(40mm brass screws)
x20 (80mm brass screws)
*IMPORTANT - if foundations required additional 450mm included
If freestanding use angle cleats and expansion bolts/excalibur bolts to secure seats onto tarmac
x2
expansion bolts / excalibur bolts
To be used to secrure seats onto tarmac

TOOLS required
REF: CP052/OT - ONE-20 BENCH
pg 3 of 7

REF: CP052/OT - ONE-20 BENCH
SOIL
TIMBER SUPPORT POST
CONCRETE
pg 4 of 7
Foundation Details

If the bench IS pre-assembled JUMP TO STEP
REF: CP052/OT - ONE-20 BENCH
pg 5 of 7
Assembly Instructions
1
2Attach T1 & T2 timbers
Using 90mm x 90mm L’s and 80mm brass screws
*ENSURE THE L’s ARE INSTALLED AS SHOWN
This ensures the holes remain offest and do not ‘cross’
CENTRE SLAT and SUPPPORTS
6
T1
T1
T1
T2
T2
T2
T2
T2
T2
ENSURE EDGE IS SANDED AFTER ASSEMBLY

REF: CP052/OT - ONE-20 BENCH
pg 6 of 7
Assembly Instructions
3
4
Add the FRONT SLAT and SUPPORTS
Using 90mm x 90mm L’s and 180mm brass screws
Add the BACK SLAT and SUPPORTS
Using 90mm x 90mm L’s and 180mm brass screws
*ENSURE THE L’s ARE INSTALLED AS SHOWN
This ensures the holes remain offest and do not ‘cross’
The 180mm brass screws will go through the FRONT SLAT
& SUPPORTS and into the CENTRE SLAT & SUPPORTS
The 180mm brass screws will go through the FRONT SLAT
& SUPPORTS and into the CENTRE SLAT & SUPPORTS

REF: CP052/OT - ONE-20 BENCH
pg 7 of 7
Assembly Instructions
5
6
Ensure L’s are assembled as shown below
This is essential ensure the brass screws do not clash/cross
Install the ASSEMBLED BENCH
Using ANGLE CLEATS with 40mm brass screws and EXPANSION BOLTS or CONCRETE INTO GROUND as per foundation drawings
OR
Position angle cleats on the INSIDE of centre support
- Use 40mm brass screws to attach angle cleat to the
support legs
- Use expansion bolts or EXCALIBUR bolts to secure the
bolts to the concrete / tarmac
Follow the FOUNDATION DETAILS on
Page 4