Crestron QM-FTSC Quick start guide

Crestron QM-FTSC
FlipTop Storage Center
Operations & Installation Guide

This document was prepared and written by the Technical Documentation department at:
Crestron Electronics, Inc.
15 Volvo Drive
Rockleigh, NJ 07647
1-888-CRESTRON
All brand names, product names and trademarks are the property of their respective owners.
©2004 Crestron Electronics, Inc.

Crestron QM-FTSC FlipTop Storage Center
Contents
FlipTop Storage Center: QM-FTSC 1
Introduction ..........................................................................................................1
Features and Functions...........................................................................1
The QuickMedia Transport System .......................................................2
Specifications .........................................................................................4
Physical Description...............................................................................5
Industry Compliance ............................................................................10
Setup...................................................................................................................11
Network Wiring ...................................................................................11
Identity Code........................................................................................12
Installation............................................................................................15
Hardware Hookup ................................................................................18
Ground Wire Connections....................................................................20
Configuration Software ......................................................................................20
Earliest Version Software Requirements for the PC ............................21
Configuring with Crestron SystemBuilder...........................................21
Configuring with SIMPL Windows .....................................................24
Programming with VisionTools Pro-e .................................................31
Example Program.................................................................................31
Adjusting the QM-FTSC Microphone Inputs.......................................31
Uploading and Upgrading ..................................................................................34
Communication Settings ......................................................................34
Uploading a SIMPL Windows Program ..............................................37
Firmware Upgrade ...............................................................................38
Problem Solving .................................................................................................41
Further Inquiries...................................................................................43
Future Updates .....................................................................................43
Return and Warranty Policies.............................................................................44
Merchandise Returns / Repair Service .................................................44
CRESTRON Limited Warranty ...........................................................44
Operations & Installation Guide – DOC. 6269 Contents •i

Crestron QM-FTSC FlipTop Storage Center
FlipTop Storage Center:
QM-FTSC
Introduction
Features and Functions
The QM-FTSC-B and the QM-FTSC-BALUM are part of the Crestron
MediaManager™ line of network devices, room control systems and signal
routing solutions. The suffix ‘-B’, and ‘-BALUM’, respectively denotes color,
e.g., QM-FTSC-B is a black unit, and QM-FTSC-BALUM has a brushed
aluminum finish. For simplicity within this guide, color suffix is omitted and the
designation QM-FTSC is used except where noted.
This Cresnet device uses QuickMedia™ technology to facilitate an
uncomplicated connection of audio, video, and computer equipment. All media
and control signals are routed via a single QuickMedia cable for simple
installation. A complete integrated room solution is created with the addition of
a QuickMedia receiver (such as the QM-RMCRX) and optional keypads or
touchpanels.
Functional Summary
• Built-in six button engravable* keypad with LEDs
• All A/V connections are on the underside, includes cables that feed
through the box (includes QM-FTCMK cable plate kit)
• 3 X 1 video switch with sync sensing and LED indicators (one
composite connector, one S-video connector, one RGBHV connector)
• 3 X 1 audio switch (two stereo RCA, one stereo 1/8” mini jack) with
audio breakaway
• One AC power passthrough
• One RGB monitor passthrough
• Two Neutrik™ combo inputs with phantom power
• One QuickMedia RJ-45 connector (on the right side)
• Two Cresnet connectors (on the right side)
* As an option, custom-engraved buttons can be designed and obtained by using the
Crestron Engraver software. Version 2.1.03 and Crestron Database 16.2.0 or later are
available from the Downloads | Software Updates section of the Crestron website
(www.crestron.com).
Operations & Installation Guide – DOC. 6269 FlipTop Storage Center: QM-FTSC •1

FlipTop Storage Center Crestron QM-FTSC
NOTE: The QM-FTSC is compatible with 2-Series control systems only.
QM-FTSCD Block Diagram
Keypad
Microphone 1 Microphone 2
Computer Audio
S-Video Audio
Composite Video
Audio
Phantom Power
Computer RGB
S-Video
RGB Monitor
3 X 1 Audio Switch
Video Sync Sensing
3 X 1 Video Switch
A/D
Converter
A/D
Converter
Input
Gain
Cables
Computer Audio
S-Video Audio
Composite Video Audio
Computer RGB
S-Video
Composite Video
Buffer
Cresnet
Cresnet
MIC 1
MIC 2
Program L
Program R
Video
AC Power
QM
Output
Composite Video
AC Power
The QuickMedia Transport System
Using a new, proprietary signal routing solution, signals such as composite
video, S-video, RGBHV, audios, and microphone, are all transported using a
single cable solution called QuickMedia™ (QM).
The QM transport system port is capable of managing computer, video, and
audio signals simultaneously through one CAT5E/UTP1 wire, simplifying
installations.
Routing CAT5E/UTP1 cable is less expensive and much simpler than routing
multi-colored, multi-conductor coax cable. All Crestron products using the QM
transport system are capable of sending and receiving QM signals via standard
CAT5E unshielded twisted pair (UTP) cable. Crestron recommends Belden
Media-Twist cable, and Liberty Cable Crescat-QM. Installation of any QM
device is as simple as installing one set of QM wires from output to input.
Installations are flexible, affordable, and fast.
2 •FlipTop Storage Center: QM-FTSC Operations & Installation Guide - DOC. 6269

Crestron QM-FTSC FlipTop Storage Center
The Crescat-QM cable contains one CAT5E cable and one Cresnet®cable in a
siamese jacket. If you choose to use Belden MediaTwist or other CAT5E for the
AV signals, then you need to install a separate Cresnet cable for control and
power.
QuickMedia Cable – CRESCAT-QM
The pin assignment is based on the EIA/TIA 568B RJ-45 Jack standard.
To determine which pin is number 1, hold the cable so that the end of the eight
pin modular jack is facing you, with clip down and copper side up. When
looking down at the copper connections, pin 1 is on the far right.
QuickMedia Pin and Pair Assignment
RJ-45 Male Connector RJ-45
Pin
Number
CAT5E
Pair
Number
Wire Colors QM
Assignment
RGB and Audio
QM Assignment
Composite,
S-video and
Audio
1 2 White/Orange - RGB Red - Chrominance
2 2 Orange + RGB Red + Chrominance
3 3 White/Green - RGB Green - Luminance
4 1 Blue + Audio + Audio
5 1 White/Blue - Audio - Audio
6 3 Green + RGB Green + Luminance
7 4 White/Brown - RGB Blue - Composite
8 4 Brown + RGB Blue + Composite
The total accumulated skew from QM transmitter to QM receiver must not
exceed 15 ns (nanoseconds). Crestron recommends a cable with a rating of less
than or equal to 15 ns over its entire length. For example, if using a cable with a
rating of 15 ns/100 meters (100 meters = 328 feet), connecting the QM-
WMC/QM-WMIC QM transmitter with 150 feet of cable to a QM-MD7x2
switcher, and then using another 150 feet to connect the QM-RMCRX receiver,
the accumulated skew over the entire 300 feet should not exceed 15 ns.
Operations & Installation Guide – DOC. 6269 FlipTop Storage Center: QM-FTSC •3

FlipTop Storage Center Crestron QM-FTSC
Specifications
Specifications for the QM-FTSC are given in the following table.
QM-FTSC Specifications
SPECIFICATION DETAILS
Power Requirements 8 Watts (0.33 Amp @ 24 VDC)
Default Network IDs 04 (QM-WMC/QM-WMIC)
73 (C2N-DB6)
Video Formats Composite, S-video, RGBHV
Video Detection Within 2 seconds
Firmware QM-WMC.V.2.24.upg or later
PK_C2NDB6.V1.00a.csf or later
2-Series Control System
Update Files1,2
Version 3.093.CUZ or later
Connectors
Computer Input (1) DB15HD female, video sensing on H-sync
Computer Output (1) DB15HD female for monitor out
Computer Audio (1) 3.5mm mini-jack, computer soundcard type
Composite Video (1) RCA (yellow), video sensing
Composite Video Audio (2) RCA (red and white)
S-video (1) Mini-DIN 4-pin, video sense on luminance
signal
S-video Audio (2) RCA (red and white)
QuickMedia Output (1) RJ-45 CAT5
Cresnet (2) 4-pin terminal block
Ground (1) Ground Terminal
Microphone (2) Neutrik Combo: XLR & ¼” phone per input
Video
Types Composite, S-video, and RGB
Video Sensing Automatic sensing of composite, S-video
(luminance), and RGB (H-Sync) with
corresponding LED indicators
Gain 0 dB (unity gain, 75 Ohm termination)
Maximum Input Voltage 1.0 V p-p
Input Impedance 75 ohms
Bandwidth
(Composite &
S-video)
> 100 MHz (-3 dB) at unity gain
Max Resolution/Refresh
Rate (RGB)
1600 x 1200 @ 60 Hz vertical rate with
CAT5/5E/6 cable length of 100 meters and
skew rating ≤15 ns / 100 meters3
H and V Sync (RGB) 5.0 V p-p max into 1 KΩ
Specifications continued on next page.
4 •FlipTop Storage Center: QM-FTSC Operations & Installation Guide - DOC. 6269

Crestron QM-FTSC FlipTop Storage Center
QM-FTSC Specifications (continued)
SPECIFICATION DETAILS
Audio
Analog-Digital Conversion 24 bit / 48 kHz
Maximum line-level input 2 Vrms/ 6 dBVrms (Video)
1 Vrms/ 0 dBVrms (PC)
Input Impedance 10k ohms
Bandwidth 20 Hz to 20 kHz
Operating Temperature and
Humidity
41º to 104º F (5º to 40º C)
10 to 90% relative humidity
(non-condensing)
Dimensions and Weight Width: 8.26 in (20.98 cm)
Height: 6.08 in (15.44 cm)
Depth: 6.23 in (15.82 cm)
Weight: 8.8 lbs (3.99 kg) with cables
1. The latest software versions can be obtained from the Downloads | Software Updates section of
the Crestron website (www.crestron.com). Refer to the NOTE following these footnotes.
2. Crestron 2-Series control systems include the AV2 and PRO2. Consult the latest Crestron Product
Catalog for a complete list of 2-Series control systems.
3. Longer lengths of CAT5/5E/6 cable can be used. However, the cumulative skew must be ≤15 ns
for the entire length of cable used between all QM devices. Longer lengths of cable may
experience eventual loss of bandwidth when viewing higher resolution sources. For more
information, refer to page 3.
NOTE: Crestron software and any files on the website are for Authorized
Crestron dealers and Crestron Authorized Independent Programmers (CAIP)
only. New users may be required to register to obtain access to certain areas of
the site (including the FTP site).
Physical Description
Refer to the physical views shown below.
Top View Bottom View
Operations & Installation Guide – DOC. 6269 FlipTop Storage Center: QM-FTSC •5

FlipTop Storage Center Crestron QM-FTSC
Physical Dimensions - Top View Bottom View
8.26 in
(20.98 cm)
6.23 in
(15.82 cm)
Back View Right Side View
7.76 in
(19.71 cm)
6.08 in
(15.44 cm)
5.12 in
(13.00 cm)
5.19 in
(13.19 cm)
6 •FlipTop Storage Center: QM-FTSC Operations & Installation Guide - DOC. 6269