CROWNFUL IM2102-UL User manual

0
CROWNFUL ICE MAKER
INSTRUCTION MANUAL
SKU：CF-IM01 Model: IM2102-UL
Read this manual thoroughly before using and save it for future reference

1
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker,
follow these important safety instructions:
1. Before using, check if the voltage power corresponds to the one shown on the
appliance nameplate or manual. This appliance only works with 120v.
2. Do not remove any safety, warning, or product information labels from your ice maker.
3. This appliance must be grounded. It is equipped with a power cord with a grounding
plug. The plug must be plugged into an outlet that is properly installed and grounded.
4. Avoid the use of an extension cord because it may overheat and cause a risk of fire.
However, if it is necessary to use an extension cord, please do the following:
⑴Use only extension cords with grounding plug.
⑵The marked rating of an extension cord must be equal to or greater than the rating of
this appliance.
⑶It should be positioned in such that it does not drape over the counter or tabletop
where it can be pulled by children or others accidentally.
5. Do not operate any appliance with a damage cord or plug or after the appliance
malfunction or has been damaged in any manner. Return the appliance to the nearest
authorized service facility for examination, repair or adjustment.
6. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
7. Do not let the power cord hang over the edge of the table or counter.
8. Do not place on or near a hot gas or electric burner or in a heated oven.
9. Place the power cord in such a way that it cannot be pulled by children or cause a
tripping hazard.
10. Place the power cord in such a way that it is not in contact with hot surfaces.
11. The use of attachment or parts that are not recommended or sold by manufacturer
may cause fire, electric shock or injury.
12. Do not touch the evaporator when using the ice maker or when making ice to avoid

2
frostbite or other issues.
13. Do not immerse any part of the product in water.
14. To disconnect, turn all controls to “OFF”, then remove the plug from wall outlet.
15. Do not plug or unplug product with wet hands.
16. Unplug the product before cleaning, maintaining and when not in use.
17. Do not use with water that is microbiologically unsafe or of unknown quality.
18. Do not clean your ice maker with any flammable fluids. The fumes may create a fire
hazard or explosion.
19. Do not overturn the ice maker. If the ice maker is overturned accidentally, make it
stand steadily for 2 hours before turning it on again.
20. If the ice maker gets cold when it is exposed outside during winter time, please allow
the unit to warm up to the room temperature first, let it adjust for a few hours before
operating.
21. Never put flammable, explosive and corrosive substances into the ice maker.
22. Never use the ice maker when there is a flammable gas leakage.
23. Never store or use gas and other flammable substance or devices near the ice maker to
avoid any fire.
24. Unplug the ice maker before moving it to avoid damaging the refrigerating system.
25. Do not attempt to disassemble, repair, modify, or replace any parts of your product.
26. This appliance is not intended to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
are given supervision, assistance or instruction concerning the use of the appliances by a
person responsible for their safety.
27. Children should be supervised to ensure that they do not play with the appliance.
28. Close supervision is necessary when any appliance is used by or near children.
29. Do not leave the appliance unattended while in use.
30. Do not use outdoors.
31. Do not use the appliance for other than its intended use.
32. When disposing or recycling the unit, please dispose the ice maker properly according
to the local regulations in your area as it uses flammable blowing gas and refrigerant.
33. Please check your area’s programs and local regulations regarding the

3
environmentally responsible way of recycling or disposing appliances with flammable
refrigerant and blowing gas to ensure safety and compliance.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
KNOW YOUR ICE MAKER
Toplid
Viewingwindow
Frontcover
Backhousing
Fronthousing
Evaporator
Icetray
Iceshovel
Waterreservoir
Controlpanel
Infraredlight-emittingdiode
Infraredlight-receivingdiode Filter
Drainplug
"MAX"waterlevel
Icebasket
Icespoon
Holeplug
(Product may be subject to change without prior notice)

4
CONTROL PANEL
Key (with indicator)
Function
ON/OFF
Start or stop the appliance；
Long press for cleaning；
ICE
Standby mode: “ICE” indicator blinks;
Cleaning mode: Alternating “ICE” /“ICE
FULL”/“ADD WATER” indicator light
blinks rapidly；
Working condition: “ICE” indicator light is
solid.
ICE FULL
“ICE FULL” indicator lights up when the
ice basket is full.
ADD WATER
“ADD WATER” indicator lights up when
the water reservoir lacks water.

5
BEFORE FIRST USE
1. Unpack the appliance, then check and make sure that all the accessories including ice
basket and ice scoop etc. are complete. Please contact customer support or the seller if
some accessories are missing.
2. Please ensure the ice maker is leveled on a flat surface and on a stable table or platform
to avoid malfunction.
3. The inclined angle of the ice maker cabinet should not exceed 45 °during
transportation or use. Do not turn the ice maker upside down. Doing so could cause the
compressor or refrigerating system to operate incorrectly. Please allow time for the fluids
in the compressor to settle after the ice maker is moved or transported. Before using the
ice maker for the first time, please wait for 2 hours after the unit has been leveled and
positioned in the proper place.
4. The appliance must be placed on a dry and leveled surface with sufficient ventilation,
far from heat sources such as ovens, heaters and corrosive gases. Leave about a 6-inch
(15cm) clearance on all sides of the ice maker for proper ventilation.
5. Do not fill the water reservoir with hot water. This may damage the ice maker. It is best
to fill the water reservoir with water of room temperature or lower.
6. Do not use the appliance at a very cold environment (lower than 5℃).
7. Clean the appliance by following the instructions of “CLEANING AND
MAINTENANCE”before operating the unit.
USINGYOUR ICE MAKER
1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice maker into the wall outlet, the “ICE”indicator blinks.
NOTE: Allow the unit to settle for 30 minutes before plugging it if it has been moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
NOTE: Do not fill above the MAX water level mark.
5. Put the ice basket back and close the top lid.

6
6. Press “ON/OFF”key, and the “ICE” indicator light will turn on (solid light).
7. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient
temperature and water temperature.
8. The ice-making cycle starts with the water being pumped into the ice tray situated
below the evaporator. Over the next 7-15 minutes the ice forms on the evaporator. Once
it’s completed, the ice tray will tilt backwards and the remaining water in the ice tray is
drained back into the water reservoir. The ice cubes are then formed and dropped from the
evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will
automatically move back into position under the evaporator and starts the next cycle.
9. The “ICE FULL”indicator will light up when the ice basket is full and then the ice
maker will stop the ice-making cycle automatically. Gently remove the ice from the ice
basket with the ice scoop. About 7.5 seconds later, the ice maker will restart its ice
making function automatically.
10. The “ADD WATER” indicator will light up when the water reservoir lacks water so
the ice-making cycle will stop automatically. At that time, remove the ice basket and add
water to the water reservoir, and then press “ON/OFF” key again to restart the ice-making
cycle. The appliance will start working automatically after about 20 minutes if the
operator forgets to restart the appliance after refill.
11. When you finally get your desired amount of ice, stop the ice making cycle by
pressing the “ON/OFF” key and unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice maker to reach room temperature.
14. We suggest replacing the water every week or when its quality or safety gets
compromised e.g., If it has any strange color or smell. Please empty the water reservoir if
the ice maker is not used for a long time.

7
CLEANINGAND MAINTENANCE
To ensure cleanliness, quality and safety, we recommend that you clean your ice maker at
least once a week.
1. Stop the ice-making cycle by pressing the “ON/OFF” key, unplug the ice maker from
the wall outlet and allow it to warm up to room temperature.
2. If residual water is found in the ice tray, gently push the ice tray back so that all water
drains into the water reservoir.
3. Move the appliance forward to a place 60mm away from the working table and open
the drain plug to drain out excess water (see Fig.1, Fig.2 and Fig.3).
4. Remove the ice basket.
5. Clean the ice maker interior with a soft cloth soaked with warm water and vinegar,
then rinse with clean water and then drain all the water.
6. Remove the drain plug and return it back properly. Wash the ice basket and ice scoop
in warm soapy water. Rinse and dry.
7. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing
soap, if necessary.
NOTE:
⑴Do not use organic solvent, boiling water, detergent, strong acid and strong alkali etc.
for cleaning.
⑵Do not clean the evaporator.
8. Please empty the water reservoir and dry it for storage if the ice maker is not used for a
long time.

8
（Fig.1）
（Fig.2）（Fig.3）

9
TROUBLESHOOTING
Problem
Possible causes
Solution
“ADD WATER”
indicator turns on
1.Low water level or lack of
water
2.The water screen at the bottom
of water reservoir is blocked.
3.Pump malfunction.
1.Stop making ice, refill
water and then press
“ON/OFF”key to restart the
ice-making cycle.
2.Clean the unit.
3.Send it to the authorized
department for repair.
“ICE FULL” indicator
lights up
1.Ice basket is full and the
infrared light is blocked by the
ice.
2. Infrared light-emitting diode
& light-receiving diode do not
work
1. Remove the ice from ice
basket.
2a. Wipe up any foreign
objects on the infrared
light-emitting diode &
light-receiving diode and
restart the ice maker.
2b. Call Customer Service if
the infrared light-emitting
diode & light-receiving
diode will still not work
after wiping any possible
foreign objects and
restarting the cycle.
The ice collects or
melts together.
Prolonged ice making process,
insufficient cooling or something
is blocked inside.
Stop making ice, check the
basket for any blockage or
any large clumps of ice
(Remove it) and restart the
ice-making cycle after the
ice melts.
The water in the water reservoir
is of too low temperature.
Fill the water reservoir with
water ranges between 8℃
and 25℃.
The ice-making cycle
seems normal but no
ice is produced.
The ambient temperature or
water temperature is too high.
Start the ice-making cycle at
an environment with an
ambient temperature less

10
than 32 °C and fill the
water reservoir with some
cold water.
Leak on the Refrigerating system
Contact customer service
Blocked refrigerating system
Contact customer service
Poor ice-making result
1.Poor heat dissipation.
2.The water temperature is too
high.
3.The ambient temperature is too
high.
1. Leave at least 6-inch
clearance on all sides of the
ice maker for proper
ventilation.
2. Fill the water reservoir
with water ranges between
8℃ and 28℃.
3. Operate the ice maker at a
environment with an
ambient temperature
between 10℃ and 32℃.
TECHNICAL PARAMETERS
Model: IM2102-UL
Applicable climate: ST/SN/N/T
Class: I
Power source: 120V/60Hz
Rated current: 1.7A
Net weight: 7.99kg
Housing: SUS304
Foaming agent: C5H10
Refrigerant/Refrigerant amount: R600a / 23g
Unit size（DXWXH): 310*230*325mm

10
CUSTOMER SUPPORT
Should you encounter any issues or if you have any questions regarding your new product,
feel free to contact our helpful Customer Support Team. Your satisfaction is our goal!
Email: [e-mail]
Support Hours
Monday - Friday:
9:00 am - 5:00 pm PST
* Please have your order invoice or order number ready before contacting
customer support.