Crownline RPB-182 User manual

RPB-182
Crownline Smart Bidet
Instruction Manual
EN
AR

2
English
Overview
Part Names:
1. Pump
2. Rubber cover
3. On/off switch
4. Socket cover
5. Filter
6. Filter Cover
7. Hose
8. Inlet Connector
9. Outlet Connector
Specifications
Volt:
3.7V
Capacity of Battery:
2200mAH
Max. Electric Flow:
2.2A
Using time:
45~60mins
Water flow:
2.5L/min
Charging way:
Any USB output of 5V, 0.5-2A
Power supply:
Lithium-ion Battery
Charging time:
1.5-5H (Depend on charging method)
10. O-ring
11. Mini Spray head
12. Holder
13. Hook
14. Suction cup
15. USB charging cord
16. Adaptor
17. Folding bucket
18. Storage bag

3
English
Using the Smart Bidet
Assembly
Attach the inlet connector to the pump. Insert the o-ring into the outlet connector.
Attach the outlet connector to the spray head. See to it that both connectors are tight.
Usage
Immerse the pump into water. Press the on-off switch to start the pump. Use the
included hook or holder to hang and position the spray head. See to it that the pump is turned off
before it is removed from the water. It should never operated without water.
Charging
Open the socket cover. plug the USB charging cable into the charging socket. Insert the
USB connector in a computer, or included charger or a car charger.
Note: Charge the battery at least once every three months, even if you don’t use it. The pump will
turn off automatically if the voltage drops beneath 2.7V. Charge the battery anew.
Maintenance










4
English
Disassembly
Turn off the pump by pressing the on-off switch. Unscrew the hose from the spray head and
pump. Remove the o-ring from the outlet connector.
Cleaning the filter
Open the filter cover. Clean both filter and cover. Assemble filter and cover when done.