Crownline RPB-220 User manual

PORTABLE & RECHARGEABLE
OUTDOOR BIDET RPB-220

1
IMPORTANT SAFETY INSTRUCTIONS
1. PLEASE READ ALL INSTRUCTIONS BEFORE USING THEAPPLIANCE.
2. KNOW HOW TO STOP THE PRODUCTAND BLEED PRESSURES QUICKLY.
3. FOLLOW THE MAINTENANCE INSTRUCTIONS SPECIFIED IN THE MANUAL.
4. OPERATE ONLY WITH WATER WITHIN THE TEMPERATURE RANGE 10°C to 50°C.
5. SHOWER ASSEMBLY INCLUDES SMALL PARTS THAT COULD BE ACHOKING HAZARD.
WARNING
TO REDUCE THE RISK OF INJURY:
1. Do not leave appliance unattended when in use. Switch the unit off and remove from water when not in use.
2. Use only as described in this manual with manufacturers recommended attachments and replacement parts.
3. Do not use the shower with water from the sea, or muddy/dirty condition water from pool or river.
4. Make sure charger port is closed tight before using, and do not put the battery supply into water.
5. Ensure that the base of the pump is fully submerged in water before operation.
6. When the shower is operated by children, proper instruction and attention should be given.
7. Recharge the battery using specification required. Output: 5V / 0.5-2A.
8. Do not use damaged power cord or plug and charge only with correct voltage as listed on the rating plate.
Using improper voltage may result in damage to the battery and possible injury to the user.
9. Before use, ensure that there are no broken or worn parts and that all screws are fully tightened.
10. Keep the device away from heating or fire.
11. Keep the device away from freezing. Freezing will damage the motor and cord.
12. Do not disassemble your machine. This will void all warranties.
13. Do not charge the battery overnight or over charge.

2
FEATURES
1) Filter cover
2) Filter screen
3) Pump
4) O-ring
5) Outlet connector
6) Battery supply
7) Shower Sprayer
8) Hand Sprayer
9) Holder
10) J Hook
11) Suction cup
12) USB Charging Cord
13) Carry bag
14) Water Bucket 8L
15) Travel Adapter

3

4
HOW TOASSEMBLE
HOW TO OPERATE
HOW TO RECHARGE
Insert O-ring (4) into
outlet connector (5).
Attach outlet connector (5) to shower
sprayer (7) or hand sprayer (8) and
tighten by turning anti-clockwise.
Plug in the power cord to the
socket of batter supply (6)
Immerse pump (3) into water
bucket (14) filled with water.
Press on/off switch on battery
supply (6) to start.
Position shower sprayer (7) using
supplied hook (10) or holder (9).
The battery supply (6) can be
attached on the hose.
Remove the battery supply
(6) from main device.
Insert USB cord (13) into charging
socket of battery supply (6).
Note: Charging Indicator
LED Red: Battery is being charged.
LED Blue: Battery is fully charged
Plug USB cord (12) into:
- Mobile phone charger (3.5h)
- USB output from car (3.5h)
- USB output from laptop (5h)
(approximate charging time)

5
GENERAL MAINTENANCE
FOR SHOWER DEVICE
1. Unattached the shower device
IMPORTANT: Please store the pump & battery away from high temperature, freezing, flammable & explosive
goods.
2. Filter Cleaning
Remove filter cover (1)
Clean the filter (2) and filter
cover (1)
Replace filter (2) and filter cover (1)
FOR BATTERY SUPPLY
1. We recommend charging the battery to SOC 40%-50% after each use to ensure the maximum battery life. Please
charge before using for the first time.
2. Please recharge the battery at least every three months to ensure it remains in a SOC 40%-50% –the battery will
deplete when stored for long periods.
3. Do not charge the battery beyond output specification the products required (Output: 5V / 0.5-2A.).
4. Store away from high temperatures or flammable & explosive goods.
5. Only use the charger cable provided with unit and do not over charge the unit.
SPECIFICATION
Voltage:
3.7V
Hose:
1.8m
Max. Electric Flow:
2.6A
USB Charging Cord:
0.8m
Water flow:
3.5L/min
Power supply:
Rechargeable Lithium Battery Supply included
Battery Capacity:
2200mAh
Charging way:
Any USB output of 5V, 0.5-2A
Using time:
40minutes
Charging time:
3.5 hours
Stop the device by
pressing the on/off switch
on battery supply (6).
Take out the pump (3) from
water bucket (14) and detach
shower sprayer (7). Drain any
water from hose.
Remove O-ring (4) from outlet
connector (5) and store safely.