Crye Precision JPC SIDE PLATE POUCH SET MARITIME User manual

JPC SIDE PLATE POUCH SET MARITIME
P/N: MLC-044
© CRYE PRECISION LLC. ALL RIGHTS RESERVED.
MADE IN THE U.S. FROM U.S. MATERIALS
WWW.CRYEPRECISION.COM

INSTALLATION INSTRUCTIONS
REV 031318
SKELETAL CUMMERBUND ATTACHMENT
FRONT CARRIER ATTACHMENT
Lay the cummerbund at as shown. Position the side plate
pouch under the cummerbund. Ensure that the pouch
straps open towards the top edge and plate pocket opening
of pouch opens towards the bottom edge. The pouch can
be installed anywhere along the SKELETAL™ CUMMERBUND
MOLLE.
Weave the hook strap of the plate pouch through the
webbing openings of the cummerbund and pouch. The
strap should rst go through the opening in between the
two layers of cummerbund webbing and then through the
webbing of the pouch. Secure the remainder of the strap
onto the plate pouch as shown. Weaving the strap through
the two layers of the SKELETAL™ CUMMERBUND retains the
ability to attach other items to the MOLLE on the outside of
the cummerbund.
1
2
Secure the pouch to the buckles by weaving the straps
through the webbing on the pouch. Secure the straps to the
hook and loop panels.
TIP
It may be helpful to twist the straps over while weaving
them through the webbing. This will prevent the hook and
loop panels from catching until the strap is in its upright
position.
Lay the front carrier at as shown. Open the front ap of
the carrier. Locate the two buckles on the side edge of
the carrier. Position the side pouch so that the straps face
upward. Open the straps of the side pouch and insert them
into the buckles as shown.
1
2