crystal coolers K2 User manual

Quick Start Guide
1. Stand cooler upright on flat, smooth floor. Align
sides plate with base, and slide into base to
locked position. The side plates are inserted so
that the inner faces mount flush in the rear of the
cooler. There will be an open triangular area in
the front.
4. Plug power supply cord into receptacle. Please
ensure that cooler is set up so as access to the
power outlet and plug is unobstructed.
Note: To provide additional protection from
the ris k of shoc k, t his unit M U S T be
connected to a ground fault circuit interrupter
(GFCI) outlet at all times. Use of an extension
cord will void any warranties.
OPERATION
2. Place the water cooler indoors, on a flat level
surface in a cool shaded the location near a
grounded wall outlet. Position water dispenser
so that the back of the unit is a minimum of 4
inches away from the wall to ensure proper
ventilation.
ENSURE THE COOLER STANDS UPRIGHT FOR 24 HOURS BEFORE P LUGGING IT IN.
K2 Water Cooler
3. Install a bottle of water on the top of the water
cooler. Note: To prevent water leaks, a NON-
SPILL Bottle Cap MUST be installed on the
bottle. Ensure that the hot water switch near the
top of the rear panel is turned off. Light will be
green when the hot water switch is in the off
position.
The light shows as when the power to Hot RED
System is turned on.
4 inches

The customer acknowledges that water, like other liquids, can cause damage to surfaces. The
customer takes full responsibility for placing the cooler within a residence or business, and
acknowledges that failure to address drips, leaks or spillages is at the customer's risk.
5. Depress the water lever to fill the hot tank. Hot
When water begins to flow from the hot outlet
the tank is full (approx. 1 minute).
The water tank will fill automatically Cold
(approx. 3 minutes).
EX TERN AL PARTS OF TH E WATER COOL ER
Front View Back View
Light sensor
Cold Water Lever
Hot/Cook Water Lever
Dispense Area Lighting
Drip Tray
Cup Dispenser
Cold LED
Cook / Hot LED
CrystalFlo LED
Hot Water Activation Switch
Water Outlet
CrystalFlo Water Cartridge
replaceable reservoir system
RECOMMEN D E D T O CHA N G E EVERY 12 M O NTHS
6. Ensure Priming of Hot water system is
complete before starting this step
Turn on the hot water switch. To disable the
heating function ( Water), turn off the hot Hot
water switch. draw water from the DO NOT
cooler for about 30 minutes to let the water
cool or heat. Optimum water temperatures will
be reached after 1-2 hours of operation.
Wait 30 minutes to draw
cold or hot water
To fill the hot tank full
(approx. 1 minute)