CTA PAD-CHKWM10 User manual

Thin Profile Floor Stand
with Removeable Magnetic Protective Case (White)
PAD-CHKWM10
INSTRUCTION - MANUAL
888-733-4448
CONTENTS:
1. INSTALLING BASE:
ALIGN BASE PLATE (B) WITH THE BODY (A) AND
ROTATE IN SCREWS (G) FROM THE BOTTOM USING THE PROVIDED
ALLEN KEY TOOL (H) AND RELATED HARDWARE NEEDED.
2. SETTING UP
CABLE ROUTING
INSTRUCTIONS:
SLIDE IN THE POWER CORDS
AND ANY OTHER CORDS THAT
WOULD NEED TO BE
CONNECTED TO THE TABLET
THROUGH THE BODY AS
SHOWN. THERE WILL BE GAPS
AT THE TOP AND BOTTOM FOR
THEM TO ROUTE OUT TO THE
POWER SOURCE AND TO THE
DEVICE
A
x2
M5 Nut
B
CD
EFGH
M5x12 (4) M5x12 (4) M5 Allen Key
I
Metal Anchor
G
A
H
**Wire and Cord for Illustration
Purposes Only and Not Included

888-733-4448
3. MOUNTING MAGNETIC PLATE AND TABLET CASE
ALIGN THE VESA HOLES ON THE MAGNETIC PLATE (D) WITH THE VESA MOUNT ON THE BASE BODY (A).
USING THE SPECIAL ALLEN KEY (H), ROTATE IN SCREWS (F) FROM THE FRONT WHILE HOLDING THE HEX
NUTS (E) FROM THE BACK BEHIND WITH FINGERS. SCREW IN UNTIL SECURELY TIGHTENED. REPEAT FOR
ALL (4) SCREWS. ONCE MAGNETIC PLATE IS ATTACHED, LAY MAGNETIC CASE ONTO THE PLATE FOR A
FLOOR STAND SETUP.
C
H
F
E
D
A
(OPTIONAL) BOLTING FLOOR STAND DOWN
USING A POWERDRILL OR SIMILAR (NOT PROVIDED) THAT IS THE SAME
SIZE AS YOUR METAL ANCHOR - CREATE A CAVITY IN THE FLOOR. INSERT
THE BASE PART OF THE METAL ANCHOR (I), AND SCREW IN THE NAIL
COMPONENT OF THE METAL ANCHOR (I) FROM ABOVE WITH A SCREW-
DRIVER (NOT PROVIDED) UNTIL SECURELY TIGHTENED. REPEAT FOR ALL
HOLES.
I
I
**Screwdriver for Illustration
Purposes Only and Not Included