Cube Design 5202ECO User manual

10
2 3 4 5
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: [phone] | [email protected] | www.cube-design.dk/en
5202ECO Quadro pull-out cabinet
a product by Cube Design
Phone no.:
E-mail:
Website:
Warranty:
Use:
Test:
Product description:
Pull-out cabinet for storing folders,
books etc. made of chipboard lined
with laminate and 2 mm ABS edges.
NOTE: You can always contact Cube
Design for spare parts for your pull-out
cabinet or other Cube products.
No biocides or disinfectants have been
used on this product.
[phone]
[email protected]
www.cube-design.dk/en
10 years
Only for indoor use
EN16121+EN16122
Design for disassembly
Pull out the pull-out cabinet to the outer position.
Use both hands to release the clutch under the cabinet.
Now the two parts can be seperated.
Remove the metal logo
with the screwdriver.
Remove the list at the top
by unscrewing the seven
screws with the Phillips
screwdriver.
Pull the felt off the list.
Continued on the back ►
Remove both pull-out
brackets by unscrewing
the four screws from each
bracket with the Phillips
screwdriver.
Lay the box on the side.
Remove the feet by un-
screwing the three screws
from each foot with the
Phillips screwdriver.
Disassembly tools:
1x at-head screwdriver
1x Phillips screwdriver
1x rubber hammer

CUBE
DESIGN
3
5
2
4
1
7 8 96
10
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: [phone] | [email protected] | www.cube-design.dk/en
5202ECO Quadro pull-out cabinet
Hit the shelves with a rub-
ber hammer from below.
Remove the shelf support
by hitting with the rubber
hammer from above.
Lay the bookcase on the
side. Remove the pull-out
brackets and castors by un-
screwing all the screws with
the Phillips screwdriver.
Here are the parts you have after disassembly:
1 Wood
2 Metal
3 Plastic
4 Metal and plastic
5 Felt
Remove the handle by
unscrewing the two screws
with the Phillips screwdriver.