Cube Design Modular information desk User manual

1
2
4
3
CUBE
DESIGN
Modular information desk
Phone no:
Email:
Website:
Version:
+ 45 86 98 74 11
[email protected]
www.cube-design.dk/en
02-01-2024
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: [phone] | www.cube-design.dk/en | [email protected]
It is strongly recommended to be a
two-man job, when assembling the
information desk!
Modular desk parts list:
1. Front of the corner module
2. Side of the corner module
3. Possibly center module(s)/corner module
4. Top plate – several parts
5. 9 x dowels (8 x 30 mm)
6. 9 x plastic plugs per module
7. 6 x screws (4,5 x 30 mm) per modul
8. 5 x screws (4 x 35 mm) per modul
Assembly manual for modular information desk
a product by Cube Design

CUBE
DESIGN
Assembly manual for modular information desk
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: [phone] | www.cube-design.dk/en | [email protected]
Step 2: Make the correct arrangement of the modules.
Level the modules by using the adjustable levelling feets
inside the modules base (oblong holes). Use a 5 mm
umbraco.
Step 3: Screw the corner together. Start with driving
three screws (4.5 x 30 mm) into the side.
Step 3 continued: Attach the front plate using screws
(4.5 x 30mm) through the holes.
Step 1: Place the modules in the nal location and un-
screw the back plates of the modules. REMEMBER the
right position of the back plates and save the screws for
later use.
Step 5: Place the top plate loosely on top of the modules
in the correct alignment.
Step 4: Now mount the rest of the modules with screws
– back to back.

CUBE
DESIGN
1
1
1
2
2
2
33
3
Assembly manual for modular information desk
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Phone no.: [phone] | www.cube-design.dk/en | [email protected]
Step 7: Screw the top plate from the inside of the modules
– 3 screws (4.5 x 30mm) per module.
NOTE: If you have a free-standing infomation desk, you
must x it to the wall or oor!
If you want to install power for e.g. lights/PC you can do
it now. Drill holes through the horizontal inner plates.
Step 8: Now the back plates must be installed. ATTEN-
TION! The order is important!
Place the back plate of the corner module front (1) by
using dowels and screws (4 x 35 mm).
Step 9: Insert the loose dowels into the corner module
side (2) and then insert the associated back plate by
using dowels and screws (4 x 35 mm).
Step 6: For this step it is especially important to be
two people! Now place the top plate slightly diagonally
across the modules. Attach the bracket under the corner
of the top plate. If you have an extra top plate corner
then repeat step 6. NOTE: do not assemble the top plate
on the oor – stones or unevenness will scratch the
plate.
Enjoy your new information desk!
Step 10: Insert the remaining back plates using dowels
and screws (4 x 35 mm).
Step 11: Finally, put the enclosed plastic plugs into the
visible screw holes.