5
4. Press the Defrost button. Blue LED indicates feature is
activated.
To stop cycle
When the defrost cycle is complete, the toaster will raise the bread.
If you wish to stop the cycle before it is nished, simply press the
Cancel button to interrupt.
After use, unplug the toaster from the electrical outlet.
Reheat button
The reheat feature allows you to reheat bread without browning
or toasting.
1. Insert slice(s) of bread
Be sure that multiple slices do not overlap and the carriage is in
the up position.
2. Press the carriage control lever until it locks into position.
3. Press the Reheat button. Blue LED indicates feature is
activated.
To stop cycle
When the reheat cycle is complete, the toaster will raise the
bread. If you wish to stop the cycle before it is nished, simply press
the Cancel button to interrupt.
Bagel button
The bagel feature reduces heat on one side of the toasting slot.
This toasts the cut side of the bagel slightly more than the other side.
An embossed icon located on the top of the toaster,
just above the control panel, shows you the right way
to insert your bagel. (The cut side should always face
toward the center of the pair of toasting slots.)
1. Insert slice(s) of bread or halved bagels
2. Press the Bagel button. Blue LED indicates feature is
activated.
3. Press the carriage control lever until it locks into position.
To stop cycle
When the bagel cycle is complete, the toaster will raise the bread.
If you wish to stop the cycle before it is nished, simply press the
Cancel button to interrupt.
CLEANING AND MAINTENANCE
Always allow the toaster to cool completely before cleaning.
1. Always unplug the toaster from the electrical outlet before
cleaning.
2. Do not use abrasive cleansers. Simply wipe the exterior with a
clean damp cloth and dry thoroughly. Apply any cleansing agent to
a cloth, not to the toaster, before cleaning.
3. To remove crumbs, slide out the crumb tray and discard crumbs.
Wipe clean and replace. Never operate the toaster without the
crumb tray in place.
4. To remove any pieces of bread remaining in the toaster, turn the
toaster upside down and gently shake. Never insert any hard or
sharp instruments into the slot, as this could damage the toaster
and cause a safety hazard.
5. Never wrap the cord around the outside of the toaster. Use the
cord storage cleats on the underside of the toaster
.
6. Any other servicing should be performed by an authorized service
representative.
4
USE AND CARE
Unwind the power cord. Check that the crumb tray is in place and that
there is nothing in the toaster slot. Plug power cord into the wall outlet.
1. Insert slice(s) of bread
Be sure that multiple slices do not overlap and that the
carriage is in the up position.
2. Set the browning control
Press browning control buttons (+ -) to select desired toast shade:
Dial Setting Colour
1-2 light
3-5 medium
6-7 dark
Some notes on browning
Toasting is a combination of cooking and drying of the bread. Therefore,
differences in moisture level from one bread to another can result in
varying toasting times.
•Forslightlydrybread,usealowersettingthanyounormallywould.
•Forveryfreshbreadorwholewheatbread,useahighersettingthan
normal.
•Breadswithveryunevensurfaces(suchasEnglishmufns)willrequirea
higher toast setting.
•Thicklycutpiecesofbread(includingbagels)willtakelongertotoast,
sometimes signicantly longer, since more moisture must be evapo-
rated from the bread before toasting can occur. Very thick pieces may
require two cycles.
•Whentoastingraisinorotherfruitbreads,removeanylooseraisins,etc.
from the surface of the bread before placing into the toaster. This will
help prevent fruit pieces from falling into the toaster or sticking on the
guide wires in the slot.
•Beforetoastingbagels,sliceeachbagelintotwoequalhalves.
Single slice toasting
If you are toasting a single slice of bread, set the heat selector to a lighter
setting than you normally would. The toaster is designed to heat the
whole toasting chamber for two slices. By lowering the heat for a single
slice, you won't overtoast.
Frozen waffles, pancakes, french toast and frozen bagels
These breads and pastries should be warmed using the Defrost button.
Toaster pastries
Exercise caution with toaster pastries; the lling can become quite hot,
long before the surface of the pastry becomes browned. Never leave
toaster pastries unattended while toasting or warming.
3. To begin toasting
Press the carriage lever until it locks into the down position.
4. To stop toasting
When the toasting cycle is nished, the toast will be raised. If
you wish to stop the cycle before it is nished, simply press the
Cancel button.
Tips
• Neverforcefoodsintothetoastingslot.Foodsshouldtfreely
between the guide wires.
• Donotplacebutteredbreadsorpastrieswithllingsorfrostingsin
the toaster, as this could create a re hazard.
• Uneventoastingisusuallyduetobreadslicesofuneventhickness.
• Afteruse,unplugyourtoasterfromtheelectricaloutlet.
Defrost button
The Defrost button is designed to rst defrost and then toast the bread,
which extends the toasting cycle slightly.
1. Insert slice(s) of bread
Be sure that multiple slices do not overlap and the carriage is in
the up position.
2. Set the browning control
Settings 1-2
For refrigerated breads and thinner frozen items such as
frozen pancakes.
Settings 3-4
For toaster pastries, frozen wafes and (thin) French toast,
and refrigerated bagels.
Settings 5-6
For thicker frozen items such as bagels, hand-cut bread and
thick French toast.
3. Press the carriage control lever until it locks into position.