Culer SOLO User manual

www.culer.com | 1-800-320-6478Rev. 11.17.15 1
CULER SOLOTM and DUETTM
Owner’s Manual
Thank you for choosing CULER.
PLEASE READ THESE INSTRUCTIONS AND KEEP THIS
OWNER’S MANUAL IN A SAFE PLACE.
R

www.culer.com | 1-800-320-6478 Rev. 11.17.152
Contents .........................................................................
Safety ..............................................................................
Operation .......................................................................
Care .................................................................................
FAQ .................................................................................
Troubleshooting...........................................................
Warranty ........................................................................
PAGE
2
2
3
5
10
11
12
CULER Evaporative Cooler
AC/DC Power Adapter
Quick Step Guide
Owner’s Manual
READ AND SAVE THIS MANUAL FOR FUTURE REFERENCE.
WARNING: To reduce the risk of re, electric shock, or injury:
1. Make sure that the power source complies with the electrical
requirements of the product.
2. Do not use this product with damaged or missing lter(s).
3. If the product is not working correctly, has missing parts, has been
dropped, damaged, or dropped in water, call 1-800-320-6478 for
evaluation, adjustment, or repair.
4. To protect against electrical shock, do not immerse unit, plug, or
cord in water or spray with liquids.
5. Keep the power cord away from heated surfaces.
6. Do not operate the product if the unit, power cord, or plug is
damaged in any manner.
7. Do not run the cord under any carpets, throw rugs, runners, or
similar coverings.
8. Do not route cord under furniture or appliances, and place cord
away from tracked area where it will not be tripped over.
9. Do not insert or allow any foreign objects to enter the intake or
exhaust air openings.
Table of Contents
Package Contents
Safety

www.culer.com | 1-800-320-6478Rev. 11.17.15 3
Operation
1. Remove tank cap and ll water
tank (with potable water only)
to the bottom of the ll
basket. (approximately one
gallon)
NOTE: Do not overll tank.
2. Replace cap and tighten until
fully sealed.
NOTE: Unit will not function properly if cap
is not tight.
3. Plug AC/DC power adapter
supply into the power port on
the unit. Plug the three-
pronged plug into an outlet.
4. Press the POWER button at
the top of the unit to turn on
the evaporative cooler. Green
light will illuminate.
10. Do not block or tamper with the atomizing nozzles, as it may
reduce or impede the product’s performance.
11. Disconnect the power cord before moving or performing any
maintenance on the product.
12. This product must be grounded. Plug into an appropriate ground
fault circuit interrupter (GFCI) protected outlet that is properly
installed and in accordance with all local codes and ordinances.
13. Do not hang or mount the product on a wall or ceiling.
14. This product should not be used in potentially dangerous
conditions, such as ammable, explosive, or chemically loaded
atmospheres.
15. Do not store outside or near hazardous materials.

www.culer.com | 1-800-320-6478 Rev. 11.17.154
5. Press the FAN button to turn
on fan. Adjust air speed by
pressing button:
(high, med, low) Green light
will illuminate.
6. Press the COOL button to
activate atomization. Green
light will illuminate.
7. Adjust the cooling port(s) to
the desired positions up-down
and side-to-side.
NOTE: The CULER evaporative cooler will continue to atomize for a short
time while the unit depressurizes. Be sure to turn o product before
unplugging.
Press the POWER button to
turn o. Green light will
turn o.
POWER OFF

No Water in System
When Storing
www.culer.com | 1-800-320-6478Rev. 11.17.15 5
• Clean the cooler with a soft
cloth and mild soap solution.
• Store the cooler in a clean
and dry place.
• DO NOT STORE COOLER
WITH WATER IN THE SYSTEM
FOR MORE THAN 5 DAYS.
CLEANING &
STORING PRODUCT
Care
• Unplug the power supply.
• Remove the water tank
ll cap.
• Carefully turn the cooler over
to allow water to drain out.
EMPTYING WATER TANK

www.culer.com | 1-800-320-6478 Rev. 11.17.156
• Replace ll cap and turn
until sealed.
• Plug the cooler in and run
COOL function until the
atomized water stops. CONDI
• If an unpleasant odor is
detected, a quick conditioning
of the water tank should
correct the issue.
• Completely drain water tank.
(See Emptying Water Tank)
• Fill tank with 1 gallon of
potable water.
NOTE: Do not overll tank.
• Add 3 to 5 drops of unscented
chlorine bleach to the full water
tank.
CONDITIONING WATER TANK

www.culer.com | 1-800-320-6478Rev. 11.17.15 7
• Replace cap and turn until
sealed.
• The cooler is conditioned and
ready for operation.
NOTE: Each cooler has two lters:
one for water
and one for air
• Locate the lter access doors
on the sides of the cooler.
• Place small athead
screwdriver into slot on access
door near back of unit and
gently move the screwdriver
towards back of unit until door
can be removed.
• The lters are connected to the
tubing at the blue ttings.
REPLACING FILTERS

www.culer.com | 1-800-320-6478 Rev. 11.17.158
• Press the blue ttings towards
the middle of the lter while
gently pulling the tubing out of
the lter.
• Orient the red band in the new
lter towards the rear of the
cooler.
• Firmly insert tubing into the
ttings on either side of the
replacement lter.
• Reinstall lter access door.
Repeat steps for lter on
opposite side.

www.culer.com | 1-800-320-6478Rev. 11.17.15 9
Optimal Operating Placement
GOOD AREAS
• On oor with good
airow
example - by entryway of room
• Near open window
• On a table
• Directed towards user(s)
Table
Table
Table
Table
Table
Table
Window
Entry Way
Legend: Recommended
Placement
=
CAUTION: DO NOT COVER UNIT WITH FABRIC
RECOMMENDED CLEARANCE
• 3 feet (0.9m) from front
3 feet (0.9m)

www.culer.com | 1-800-320-6478 Rev. 11.17.1510
What is the run time with COOL on and how much water
does it take?
SOLO – 10 + hours
DUET – 6 + hours
Both the SOLO and DUET will hold up to 1 gallon of water.
Can it be left outdoors?
It is not recommended to leave your cooler outside when it is
not being used. (Think of it like a portable stereo - you can use it
outdoors, but not recommended to leave outdoors.)
Where can you use the CULER evaporative coolers?
The CULER evaporative coolers were designed to be used both
outdoors and indoors.
What type of water can you ll the cooler with?
You should use potable (drinkable) water.
Does ice water make it colder?
Water temperature does not noticeably impact the cooling
performance.
What happens if the cooler runs out of water?
If the cooler runs out of water, it will simply stop atomizing water. No
harm will be done by operating the cooler without water.
Where is the best place to use the unit?
(See Optimal Operating Placement Image on page 9)
Should there be a certain amount of space around the cooler?
Yes, there should be 3 feet of space in front of the port.
(See Recommended Clearance image on page 9)
FAQ

www.culer.com | 1-800-320-6478Rev. 11.17.15 11
Troubleshooting
PROBLEM CAUSE CORRECTION
Power button
is not
illuminating
a) POWER button is
in the OFF
position
b) Power cord is not
connected
c) Wall outlet is not
providing power
a) Press POWER button one
time
b) Connect power cord and
press POWER button one
time
c) Find an alternate power
outlet
No air coming
from port
FAN button is in the
OFF position
Press FAN button to activate
(high, med, low)
No atomization
coming from
port
a) COOL button is in
the OFF position
b) Water tank is
empty
c) Tank cap is not
fully tightened
d) Water lter is
clogged
a) Press COOL button
one time
b) Fill tank with water
c) Tighten tank cap
d) Replace water lter
Water
streaming
from nozzle(s)
during
shutdown
Water tank is
overlled
Open tank cap to release
pressure. Drain tank to
bottom of ll basket. During
next start up the cooling
function may stream water
for a few seconds until the
lines have been cleared.
Water
streaming
from nozzle(s)
during
operation
Air lter is clogged Replace air lter

www.culer.com | 1-800-320-6478 Rev. 11.17.1512
Warranty
1 YEAR LIMITED WARRANTY
• The CULER evaporative cooler is warranted for one year from the
date of purchase against defects in materials and workmanship. At
our discretion, parts that prove to be defective will either be
repaired or replaced, or the whole product will be replaced. In either
case, a copy of your proof of purchase will be required.
• In case any mechanical or electrical repairs are required during the
warranty period, send your complete product, postage or freight
prepaid to the CULER service location.
• This warranty does not include the air or water lters. This warranty
applies for only 90 days if this product is ever used for commercial or
rental purposes.
• The serial number, model number, and manufacturing date code can
be found on the label attached to the back of the unit. You should
record these numbers and the date of purchase and keep in a safe
place for future reference.
MODEL NUMBER: ____________________________
MFG DATE CODE: ____________________________
SERIAL NUMBER: ____________________________
DATE OF PURCHASE: _________-_________-_________
PURCHASE FROM: ____________________________
Register your product online at www.culer.com/register.
THANK YOU FOR YOUR PURCHASE!