CyberData 011151 Manual

The IP Endpoint Company
Installation Quick Reference
Wall Mount Adaptor for Indoor
Paging Speakers
011151*, RAL 9002, Gray White, Standard
011152, RAL 9003, Signal White, Optional
*Replaces the 010882 number.
Quick Reference 930405D © 2018, CyberData Corporation, ALL RIGHTS RESERVED© 2018, CyberData Corporation, ALL RIGHTS RESERVED 930405D Quick Reference
Wall Mount Adapter Parts
Overall Dimensions
(1) Template for Wall Mount
Adapter and Screw Holes*
(1) Wall Mount Adapter (1) Drywall Mounting Kit
(4) Plastic ribbed anchors(4) #6 x 1.25-inch sheet metal screw
(4) Enclosure mounting screw (1) Grounding nut
(1) Enclosure to Backplate Mounting Kit
*Note: The drywall mounting kit will be included in
the ceiling speaker kit. *Install the grounding nut onto
the Backplate’s ground lug.
(3) #8-32 x 0.5 inch Non-Drive Button
Head Machine Screw
(3) #8-32 KEP Nut
(1) Speaker Assembly to Enclosure Mounting Kit
10.4 [264]
Dimensions are in Inches [Millimeter]
4.0 [102]
8°
12.6 [321]
CyberData Part #011098 or 011099
Connecting Power (PoE)
Connecting Power (optional power injector)
Contacting CyberData
Optional Power Injector
(CyberData P/N 011124)
Sales: [phone] ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: [phone] ext. 136
RMA Email: [email protected]
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: [phone]
Fax: [phone]
http://www.cyberdata.net/

4.724 [119.99]
4.000 [101.60]
10.000 [254.00]
8.000 [203.20]
Dimensions are in Inches [Millimeter]
Connect Network Cable to Speaker Assembly
Step 1
Step 2
Step 5
Step 4
Align Speaker Assembly with
Prepare Hole for Cable Access and
Drill Holes for Plastic Ribbed Anchors
Hang Wall Mount Backplate to Wall,
Clock Kit Enclosure
Secure it with Mounting Screws
Secure it with Non-Drive Button Head
Screws and Nuts
Step 3
Run Network Cable Through Wall & Backplate
or Through Cable Entry on Top
Grounding
Lug
Ground Cable
Nut
Secure it with Mounting Screws on Both Sides
Align Enclosure with Backplate
Step 6
P/N: 121001
P/N: 121009 [RAL 9002]
Cable Entry
**
Cable Entry
P/N: 121010 [RAL 9003]
Mounting
Note: Before printing this document or the mounting template, check the following:
Make sure that the Paper Size setting of the printer is set to 11x 17.
Make sure that the Page Scaling setting of the printer is set to NONE.