7
©2023 CYCMOTOR LTD
Error Codes
In certain circumstances, an error code may appear on your display. Contact us for assistance.
Error Code on App & DS103 Display
Controller Over Temperature
Controller Internal Error 1
Controller Internal Error 2
Controller Internal Error 3
Controller Internal Error 4
Controller Internal Error 5
Controller Internal Error 6
Controller Internal Error 7
Controller Internal Error 8
Controller Internal Error 9
Controller Internal Error 10
Installation
1. Determine if you need to select the corresponding mounting clamp and rubber clip ring
according to the diameter of your handlebar (Applicable handlebar specifications: Φ22.2;
Φ25.4; Φ31.8).
2. Open the display lock clamp and insert the rubber clip (if applicable) into the correct
position of the lock clamp.
3. Set the rubber ring in the bracket (if applicable) then assemble on the middle of the
handlebar. You can adjust the angle of the display to make the display screen more visible
when riding. After fixing the angle, tighten the screws. The tightening torque is 1N.m.
4. Open lock ring of the switch and set in the appropriate position on the left side of the
handlebar. Adjust the angle and position of the switch as needed in order to ensure the
switch can be operated easily.
5. Fix and tighten the handlebar fixing screw with the M3 Hex wrench (locking torque is
0.8N.m.)
Note: Damage caused by excessive torque is not covered by warranty.
