CYP AU-A220 User manual
AU-A220
Digital/Analog Stereo Audio Amplier
Driver User Guide
CONTENTS
1. Introduction..................................................1
2. Driver Properties ..........................................1
3. Device Specic Command............................ 2
3.1 Set Power................................................................2
3.2 Set System Reboot..............................................2
3.3 Set Audio Out Mute............................................2
3.4 Set Audio Out Volume .......................................2
1
1. INTRODUCTION
This driver has been designed to provide one-way control of the CYP
Digital/Analog Stereo Audio Amplier, via RS232.
2. DRIVER PROPERTIES
The property of this driver is shown below
Figure 1: Driver Properties
Driver Version Driver version number
Debug Mode Support use only
Debug Level Support use only
Command Delay Milliseconds a delay of millisecond between
commands
2
3. DEVICE SPECIFIC COMMAND
In addition to the usual Audio Amplier Controlling functionality
supported by Control4, there are a number of device specic commands
for the Audio Amplier Controlling.
3.1 Set Power
Power Status ON or Stand-by
3.2 Set System Reboot
Power Status Reboot
3.3 Set Audio Out Mute
Audio Mute Status Unmute or Mute
3.4 Set Audio Out Volume
Volume 0 to 100
Table of contents
Other CYP Amplifier manuals
