Cypress Semiconductor CYW920721B2EVK-02 User manual

CYW920721B2EVK-02 EVALUATION KIT QUICK START GUIDE
CYW920721B2EVK-02 EVALUATION KIT
Kit Contents:
1. CYW920721B2EVB-02 Evaluation board
2. CYW9BTAUDIO2 Arduino shield
3. USB Standard-A to Micro-B cable
4. Power Adapter
5. Quick Start Guide (this document)
1. Ensure that Audio shield is connected on CYW920721B2EVB-02 and jumper setting are
same as shown in the image on top.
2. Connect USB Cable between PC and CYW920721B2EVB-02
3. Connect Earphones/headphone to audio jack on shield (J10).
4. Press User Button on CYW920721B2EVB-02 for 3 seconds and then scan Bluetooth
devices on phone/PC that you want to connect to this kit. Now, pair your phone/PC
to the kit.
5. Use any audio application on your device to stream music to CYW920721B2EVK-02 and
listen to it using the plugged earphone/headphones.

CYW920721B2EVK-02 EVALUATION KIT QUICK START GUIDE
CYW920721B2EVK-02 EVALUATION KIT
© 2019 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the property of their respective owners.
002-29179 Rev.**
CYW920721B2EVB-02 Evaluation Board Details
15. Peripheral Enable (J18)
16. Thermistor Enable (J14)
17. Thermistor (R30)
18. Debug Header (J13)
19. SWD/GPIO Switch (SW9)
20. PUART Header (J10)
21. VPA_BT Select Header (J16)
22. USB Connector (J6)
23. VBAT Select (J8)
24. VDDIO Select (J7)
25. HCI UART Header (J5)
26. Motion Sensor (U2)
1. WICED Header (J1)
2. Arduino Header (J3)
3. WICED Header (J2)
4. Arduino Header (J4)
5. 8-Mb Serial Flash (U6)
6. Carrier Board (U1) with Type 1WA (CYW20721B2)
7. LED Enable (SW4)
8. LEDs (D1 and D2)
9. User Button (SW3)
10. Arduino Header (J12)
11. Reset Button (SW2)
12. Arduino Header (J11)
13. Recovery Button (SW1)
14. VDDIO Current Measurement Header (J15)
26 1 2 3 4
5
6
7
8
9101112131415161718
19
21
20
22
23
24
25