Cypress WICED CYW920706WCDEVAL User manual

CYW920706WCDEVAL EVALUATION KIT QUICK START GUIDE
CYW920706WCDEVAL EVALUATION KIT
1 Register on Cypress WICED Community
and then download and install WICED
Studio 5.1 (or later) at
www.cypress.com/products/wiced-software
2 Download the kit user guide from
www.cypress.com/CYW920706WCDEVAL
www.cypress.com/CYW920706WCDEVAL
Kit Contents:
1 CYW920706WCDEVAL
Evaluation board
2 USB Standard-A to Micro-B cable
3 Quick Start Guide (this document)
21
1 Plug the kit into a USB port on your
computer.
2 The kit is pre-programmed with the
Hello Sensor application. To learn
about the PC and phone applications
used to test the Hello Sensor application
and test procedure, follow the steps
provided in the kit guide.

CYW920706WCDEVAL EVALUATION KIT
1. GPIO Header J19
2. SPI and UART Header J18
3. Arduino Header J23
4. 1.2 V LDO Output Jumper J12
5. Power supply to BT_VDDO Jumper J3
6. 2.5 V LDO Input Jumper J10
7. 1.2 V LDO Input Jumper J9
8. Conguration Switch SW7
9. External Antenna Connector J15
10. User LED D10
11. User LED D9
12. Enable BATT Monitor J30
13. Reset Switch SW2
14. CYW20706 Supply Jumper J17
15. User Switch SW6
16. Recovery Switch SW3
17. Arduino Header J24
18. I/O Header J22
19. Arduino Header J20
20. GPIOP15 to FTDI2RX for Debug Jumper J29
21. HCI UART/FTDI header jumper J26
22. 3.3V Power Status
23. Power Switch SW4
24. Status indicator for USB Supply
25. SeeTable 1
26. Micro-USB Header (Power, Programming
and Debugging) J25
27. Arduino Header J21
© 2017 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the property of their respective owners.
002-20392 Rev.**
For the latest information about this kit, visit www.cypress.com/CYW920706WCDEVAL
CYW920706WCDEVAL EVALUATION KIT QUICK START GUIDE
CYW920706WCDEVAL Evaluation Board Details
1 2 3 4 5 6 7
8
9
10
11
12
13
14
15
16171819
20
21
22
23
24
25
26
27