Cypress CYW920735Q60EVB-01 User manual

CYW920735Q60EVB-01 EVALUATION KIT QUICK START GUIDE
CYW920735Q60EVB-01 EVALUATION KIT
1. Register on Cypress WICED Community
and then download and install WICED
Studio 6.2 (or later) at
www.cypress.com/products/wiced-software
2. To learn more about this kit, download the
kit user guide at
www.cypress.com/CYW920735Q60EVB-01
www.cypress.com/CYW920735Q60EVB-01
Kit Contents:
1 CYW920735Q60EVB-01
Evaluation board
2 USB Standard-A to Micro-B cable
3 Quick Start Guide (this document)
1 2
1. Plug the kit into a USB port on your
computer.
2. Open a Terminal Emulator such as Tera
Term and make settings as shown above.
(The Port may be different for your
computer. Use the WICED Peripheral UART
port number from the device manager.)
The terminal window will display the
thermistor resistance and the equivalent
temperature.
(Note: The temperature is transmitted over
Bluetooth LE every 5 seconds so you can
also use any mobile app that supports the
Environment Sensing Prole to test this
example project.)

CYW920735Q60EVB-01 EVALUATION KIT QUICK START GUIDE
CYW920735Q60EVB-01 EVALUATION KIT
© 2018 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the property of their respective owners.
002-23666 Rev.**
For the latest information about this kit, visit www.cypress.com/CYW920735Q60EVB-01
CYW920735Q60EVB-01 Evaluation Board Details
1. Coin Cell Holder (ZB1-bottom side)
2. 8 Mb serial Flash (U1.U1)
3. CYW20735 (U1.U3)
4. External Antenna Connector (U1.J1)
5. Carrier Module (U1)
6. PCB Antenna (A1)
7. LED Enable Switch (SW4)
8. LEDs (D1 and D2)
9. Arduino Header (J12)
10. User Button (SW3)
11. Reset Button (SW2)
12. Arduino Header (J11)
13. Recovery Button (SW1)
14. Recovery Selection and
Peripheral Power Switch (SW8)
15. VDDIO Current Measurement Header (J15)
16. SWD/GPIO Switch (SW9)
17. Thermistor Enable Header (J14)
18. Thermistor (R30)
19. Debug Header (J13)
20. PUART Header (J10)
21. VPA_BT Select Header (J16)
22. USB Connector (J6)
23. VBAT Select Header (J8)
24. VDDIO Select Header (J7)
25. Motion Sensor (U2)
26. HCI UART Header (J5)
27. Motion Sensor Interrupt Test-point (J17)
28. WICED Header (J1)
29. Arduino Header (J3)
30. WICED Header (J2)
31. Arduino Header (J4)
32. Analog MIC (MIC1)
28 29 30 31
1
5
32
7
8
9101112131516 14171819
20
21
22
23
24
25
26
27
3
2
4
6