D-Link DWL-P200 User manual

DWL-P200
Power Over
Ethernet Adapters
48V DC Power Adapter
©2012 D-Link Company. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and
specications subject to change without notice.
About Power Over Ethernet.
Check Your Package Contents
DWL-P200 Base Unit and Terminal Unit
Female-to-Female Power Connector
Ethernet (CAT5 UTP/Straight Through) Cable
Using a power supply
with a different voltage
rating will damage and void
the warranty of this product.
If any of the above items are missing, please contact your reseller.
The DWL-P200 Power Over Ethernet (POE) Adapters are designed to supply
operational power to a Network Device. These adapters eliminate the need to use an
additional AC/DC power supply at the Network Device giving you the ability to mount an
Network Device virtually anywhere in a building where power outlets are not available,
( for example in, ceilings, attics). D-Link’s DWL-P200 Adapters take advantage of the
unused cable pairs within Ethernet Cat 5 cabling. The Base Unit inserts DC voltage into
the unused wires therefore allowing the single Category 5 cable to carry both Ethernet
data and DC power to an Network Device. The POE Terminal Unit splits the data and
DC power apart, which is then supplied to the Network Device.
Warning: Please follow the
instructions in this guide carefully.
Connecting these adapters
incorrectly may result in damage to
you network devices.

2
ENGLISH
Connecting The DWL-P200
Base Unit
Terminal Unit
P+DATA OUT:
provides the data and
power to the terminal
unit. Connect this port
to the P+DATA IN on
the Terminal unit.
LAN IN: connect an RJ-45
straight-through cable to
your computer or switch.
Power In: using the
supplied 48V power
supply, connect to a
wall power outlet.
P+DATA IN: connect
a CAT 5 RJ-45
straight-through
cable from the P +
Data Out port on the
Base Unit.
LAN OUT: connect a CAT
5 RJ-45 straight-through
cable to an Ethernet
enabled device.
Voltage Selector:
used to select DC
5V/2.5A or 12V/1A
DC Out: supplies 5V 2.5
or 12V 1 amps of power.
Using the included power
cable, connect to your
Ethernet enabled device’s
power.

3
ENGLISH
Connecting The DWL-P200
Insert one end of a Cat 5 Ethernet RJ-45 cable into the “LAN IN” port of the
Base Unit. Connect the other end of the cable to your network switch or PC.
Always pair a Base unit with a Terminal unit. DO NOT connect two
Base units together, or two Terminal units together.
Plug one end of the Power Adapter into the “DC 48V IN” Base Unit and
the other end into your electrical outlet. The green “PWR” LED on the
Base Unit should light up.
Do Not mistake the “LAN IN” port with the “P + DATA OUT” port.
Incorrectly plugging the wrong Ethernet cable into the wrong Ethernet port
may cause serious damage to your network devices. D-Link will not replace
or repair products or reimburse customers for devices that become damaged
due to incorrect installation, nor is liable for any loss of business resulting in
the incorrect installation of this product.

4
ENGLISH
Connect another Cat 5 Ethernet cable from the Base Unit “P+DATA OUT”
to the “P+DATA IN” of the Terminal Unit.
Connecting The DWL-P200
Insert one end of the DC Power Cable that is provided into the Terminal
Unit, and the other end into the DC of the Network Device. The Power
LED of the Terminal Unit should light up.
Only use a CAT 5 Ethernet straight-through cable.
Use Voltage Selector to set DC output to 5V/2.5A or 12V/1A as required
by the Network Device.

5
ENGLISH
Connecting The DWL-P200
At this point, your Network Device should have power and data, and
function normally.
Connect the provided Cat 5 Ethernet cable from the Terminal Unit “LAN
OUT” to the RJ-45 LAN port of the Network Device.

6
ENGLISH
Category 5 Pin Usage
. Data: 1, 2, 3, 6
. Power: 4, 5, 7, 8
Voltage
. Input: 48VDC, 500mA
. Output: 5VDC, 2.5A or 12VDC, 1A
Ethernet
. Connector: RJ-45
. Data Rate: 10/100Mbps
. Cable: TIA/EIA - 568, Category 5
Dimensions
. Base Unit: 8.09 x 5.2 x 2.8cm
. Terminal Unit: 8.09 x 5.2 x 2.8cm
Weight
. Base + Terminal Unit: 4.1oz
Temperature
. Operating: 0°C to 40°C (32°F to 104°F)
. Storage: -40°C to 70°C (-40°F to 158°F)
Operating Humidity
. 10% to 80%
Warranty
. 1 Year
Specications
Features
. Provides DC power over existing CAT 5 cabling to Access Points.
. Transforms incoming AC power into low-voltage DC power.
. Base and Terminal Power Over Ethernet modules powers any Network Device
requiring 5V or 12V DC input.
. Protects Access Points from possible damages due to power-surges.
. Output: 5VDC, 2.5A or 12VDC, 1A
LAN Computer
D-Link Wireless
Access Point
DWL-P200
Power Over Ethernet
(Base Unit)
DWL-P200
Power Over Ethernet
(Terminal Unit)
Ethernet Cable
DC Power Cable
AC/DC Power Adapter
Ethernet Cable

7
ENGLISH
TECHNICAL SUPPORT
Australia:
Tel: [phone]
24/7 Technical Support
Web: http://www.dlink.com.au
E-mail: [email protected]
India:
Tel: [phone]
Toll Free 1800-22-8998
Web: www.dlink.co.in
E-Mail: [email protected]
Singapore, Thailand, Indonesia,
Malaysia, Philippines, Vietnam:
Singapore - www.dlink.com.sg
Thailand - www.dlink.co.th
Indonesia - www.dlink.co.id
Malaysia - www.dlink.com.my
Philippines - www.dlink.com.ph
Vietnam - www.dlink.com.vn
Korea:
Tel : [phone]
Monday to Friday 9:00am to 6:00pm
Web : http://d-link.co.kr
E-mail : [email protected]
New Zealand:
Tel: [phone]
24/7 Technical Support
Web: http://www.dlink.co.nz
E-mail: [email protected]
South Africa and Sub Sahara
Region:
Tel: [phone]
08600 DLINK (for South Africa only)
Monday to Friday 8:30am to 9:00pm South
Africa Time
Web: http://www.d-link.co.za
E-mail: [email protected]
Saudi Arabia (KSA):
Tel: [phone]
Fax: [phone]
Saturday to Wednesday 9.30AM to 6.30PM
Thursdays 9.30AM to 2.00 PM
E-mail: [email protected]
D-Link Middle East - Dubai, U.A.E.
Plot No. S31102,
Jebel Ali Free Zone South,
P.O.Box 18224, Dubai, U.A.E.
Tel: [phone]
Fax: [phone]
Technical Support: [phone]
General Inquiries: [email protected]
Tech Support: [email protected]
Egypt
1, Makram Ebeid Street - City Lights Building
Nasrcity - Cairo, Egypt
Floor 6, ofce C2
Tel.: [phone]
Technical Support: [phone]
General Inquiries: [email protected]
Tech Support: [email protected]
Kingdom of Saudi Arabia
Ofce # 84 ,
Al Khaleej Building ( Mujamathu Al-Khaleej)
Opp. King Fahd Road, Olaya
Riyadh - Saudi Arabia
Tel: [phone]
Technical Support:
[phone] / [phone]
General Inquiries: [email protected]
Tech Support: [email protected]
Pakistan
Islamabad Ofce:
61-A, Jinnah Avenue, Blue Area,
Suite # 11, EBC, Saudi Pak Tower,
Islamabad - Pakistan
Tel.: [phone]
Fax: [phone]
Karachi Ofce:
D-147/1, KDA Scheme # 1,
Opposite Mudassir Park, Karsaz Road,
Karachi – Pakistan
Phone: [phone]
Fax: [phone]
Technical Support: [phone], 34305069
General Inquiries: [email protected]
Tech Support: [email protected]
You can nd software updates and user documentation on the D-Link website.
Tech Support for customers in

8
ENGLISH
TECHNICAL SUPPORT
Iran
Unit 5, 5th Floor, No. 20, 17th Alley , Bokharest
St. , Argentine Sq. ,
Tehran IRAN
Postal Code : 1513833817
Tel: [phone],19
+98-21-88706653,54
General Inquiries: [email protected]
Tech Support: [email protected]
Morocco
M.I.T.C
Route de Nouaceur angle RS et CT 1029
Bureau N° 312 ET 337
Casablanca , Maroc
Phone : [phone]
Email: [email protected]
Lebanon RMA center
Dbayeh/Lebanon
PO Box:901589
Tel: [phone] Ext:14
Fax: [phone] Ext:12
Email: [email protected]
Bahrain
Technical Support: [phone]
Kuwait:
Technical Support: + 965 22453939 / +965
22453949
Türkiye Merkez İrtibat Ofisi
Ayazağa Maslak yolu
Erdebil Cevahir İş Merkezi No: 5/A Ayazağa /
Maslak İstanbul
Tel: [phone]
Ücretsiz Müşteri Destek Hattı: 0 800 211 00 65
Web:www.dlink.com.tr
Teknik Destek: [email protected]
073-796-2797