D-Link DSC-350 - Digital Camera - 0.35 Megapixel User manual

D-Link DSC-350
Quick Start Guide
Windows 98 Driver Installation.
1. Connect the DSC-350 Dual Mode Camera
to your computer using the USB cable
provided.
2. Windows will detect the Camera and ask
you for the drivers. Insert your Windows
installation CD in the CD-ROM and the
DSC-350 driver diskette into the floppy
drive. Press the Next button.
3. Select Search for the best driver for your
device. Press Next.
4. Select Floppy disk drives as the location
to search for the drivers and pressNext.
5. Select The updated driver and press Next.
If Windows prompts you for a file named
Minibulk.sys, type A: in the file location box
and press OK.
6. Press the Next button.
7. Press the Finish button.
8. Windows will prompt you for two more
drivers. Please repeat steps 2 through 7 for
each of the drivers.
Install the Twain Driver:
9. After the device drivers are loaded, you
must install the Twain Driver. Press the
Start button and click Run.
Continue on next page…
All manuals and user guides at all-guides.com
all-guides.com

10. Make sure the driver disk is in the floppy
drive and type A:\twain\setup in the box.
Note: Replace Awith the letter of your
floppy drive.
11. PressStart. After it finishes, press OK.
Install MGI Software:
12. Install the MGI Photosuite and MGI
Videowave software by inserting the
Installation CD into your CD-ROM. The
installation will run automatically. Follow the
onscreen instructions to finish the
installation.
To: Do This: Look For:
Turn on
Camera Hold Mode button for 3 seconds then release.
Turn Off
Camera Hold Mode button for 3 seconds then release.
Change
Resolution While pressing the Mode button, press and release the Shutter button.
320x240
640x480
1024x768
Delete Last
Picture Press the Delete button once then press the Shutter button.
Delete All
Pictures Press the Delete button twice then press the Shutter button.
Set Single
Shot While pressing the Mode button, press and release the Shutter button until single shot mode is selected.
Set Multi-Shot While pressing the Mode button, press and release
the Shutter button until multi-shot mode is selected.
Set Video While pressing the Mode button, press and release
the Shutter button until video mode is selected.
Set Single Shot
with Timer While pressing the Mode button, press and release the Shutter button until single shot with timer mode
is selected.
Set Multi-Shot
with Timer While pressing the Mode button, press and release the Shutter button until multi-shot with timer mode
is selected.
View % Memory
Remaining Press and hold the Delete button for 3 seconds, then release.
All manuals and user guides at all-guides.com