D-Link DWR-910 Manual

Technical Support Setup Procedure
Page 1 of 3
How to perform firmware upgrade of DWR-910?
Note: By default, the network name(SSID) of the DWR-910 will be in the format
dlink_DWR_910_xxxx where “xxxx” represents the last 4 characters of the
DWR-910’s MAC Address. Please find the default SSID and password on the
product label pasted on the device.
Step 1 Ensure that the device is turned on and the desired SSID is found in the list
of Wireless Networks on your Wireless Computer.
Step 2 Select the DWR-910’s Wireless Network Name. Click on Connect as shown.
Step 3 Please key in the corresponding WiFi Key as found on the label. Click OK to
proceed.

Technical Support Setup Procedure
Page 2 of 3
Step 4 Launch Internet Browser and enter http://192.168.0.1 into the address field.
Please enter default admin and leave password blank to access the menu interface.
Step 5 Click System Tab followed by Firmware Upgrade on the left-hand side as shown.
Step 6 Click on Browse. Select the firmware that you have downloaded. Click Open

Technical Support Setup Procedure
Page 3 of 3
Step 7 Put a Tick in the box beside After upgrading the new firmware, restore
configuration to factory default. Click on Apply.
Step 8 Wait for it to upload.
Step 9 Wait for it to Reboot.
Step 10 Click on OK.
--- END ---