DèLonghi DEX Series User manual

DEX Series
DEHUMIDIFIER
Instructions for use. Keep these instructions
Visit www.delonghi.com for a list
of service centers near you.
ELECTRIC CHARACTERISTICS
120 V~ 60 Hz
DÉSHUMIDIFICATEUR
Mode d’emploi . Conservez cette notice
Visitez www.delonghi.com pour y voir une liste des
centres de réparation proches de chez vous.
CARACTÉRISTIQUES ÉLECTRIQUES
120 V~ 60 Hz
DESHUMIDIFICADOR
Repase y guarde estas instrucciones.
Lea cuidadosamente este instructivo
antes de usar su aparato.
Visite www.delonghi.com para ver la lista de centros de
servicios cercanos a usted.
CARACTERISTICAS ELECTRICAS:
120 V~ 60 Hz

2
A1
A2
A3
A4
A5
A7
A
A6
A8
EN FR ES
page 4 page pág.

3
2
13
456
✔
✗
✗
B5
B
B1
B2
B3
B4

4
INTRODUCTION
Read these instructions carefully before using the appliance.
Failure to follow these instructions may result in injuries and
equipment damage.
The manufacturer is not liable for damages resulting from fail-
ure to follow these instructions for use.
Symbols used in these instructions
Important warnings carry these symbols. These warnings must
be strictly observed.
Failure to observe these indications could result in electric
shocks, serious injuries, re or damages to the appliance.
Danger!
Failure to observe the warning may result in life threatening
injuries by electric shock.
Caution!
Failure to observe the warning may result in injuries or equip-
ment damage.
Please note!
This symbol identies important advice or information for the
user.
IMPORTANT
SAFEGUARDS
Fundamental safety warnings
Danger!
Danger!This is an electrical appliance, it is therefore impor-
tant to respect the following safety warnings:
• Do not touch the appliance with wet hands.
• Do not touch the plug with wet hands.
• Make sure the outlet used is always accessible, enabling
you to unplug the appliance when necessary.
• Always unplug the appliance using the plug itself.
Never pull the cable as it might be damaged.
• To disconnect the appliance completely from the electricity
supply, you must unplug it from the outlet.
• If the appliance malfunctions, do not attempt to repair it
yourself.
Turn the appliance o, unplug from the outlet socket and
contact a Service Center.
• Do not move the appliance by pulling the power cable.
• It is dangerous to modify or alter the characteristics of the
appliance in any way.
• If the power cable is damaged, it must be replaced by the
manufacturer or an authorized technical service center in
order to avoid all risk.
• Do not use extension cords.
• The appliance must be installed in accordance with the
rules on household appliances in force in the country
concerned.
• This appliance is not intended for use for water damage
restoration of commercial/household properties.
• The appliance must be connected to a properly grounded
outlet. Have your electrical circuit checked by a qualied
electrician.
Caution!
• Keep packaging materials (plastic bags, polystyrene foam)
out of reach of children.
• The appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capa-
bilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Always supervise children. Make sure they do not play with
the appliance.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR
HOUSEHOLD ONLY
Appropriate use
This is a household appliance only.
Use this appliance only as described in this instruction manual.
These instructions are not intended to cover every possi-
ble condition and situation that may arise. Common sense
and caution must be used when installing, operating and
maintaining any electrical appliance.
General safeguards
• Do not install the appliance in rooms containing gas, oil or
sulphur or near sources of heat.
• Do not use the appliance on sloping surfaces.
• Keep the appliance at least 2 ft (61cm).away from am-
mable substances (alcohol, etc.) or pressurised containers
(e.g. aerosol cans).
• Do not rest objects on top of the appliance.

5
• When transporting, the unit must remain upright or rest-
ing on one side. Drain the condensate tank before moving
the appliance. After transporting, wait at least 1 hour be-
fore using the appliance.
• R 134a is a refrigerant that complies with European eco-
logical standards; nevertheless, it is recommended not to
pierce the cooling circuit of the machine. At the end of its
useful life, deliver the appliance to a special waste collec-
tion centre for disposal. This hermetically sealed system
contains uorinated greenhouse gases.
ENVIRONMENTAL INFORMATION: This unit contains uor-
inated greenhouse gases covered by the Kyoto Protocol.
Maintenance and disposal must be carried out by qualied
personnel only (R134A, GWP=1430).
• The materials used for packaging can be recycled. You are
therefore recommended to dispose of them in special dif-
ferentiated waste collection containers.
• Do not use the appliance outdoors.
• Do not obstruct the entrances and exits of air.
• Do not use the appliance in laundry rooms.
Operating instructions
Read these instructions carefully before using the appliance.
• Keep these instructions.
If the appliance is transferred to other owners, they should
also be given these instructions.
• Failure to follow these instructions may result in injuries
and equipment damage.
The manufacturer is not liable for damages resulting from
failure to follow these Instruction for Use.
• Please refer to the guarantee leaet for contact details.
Please note!
Keep these Instructions for Use. If the appliance is transferred
to other owners, they should also be given these instructions.
Problems and repairs
In the event of problems, rst try and resolve them by reading
the information given in the "Troubleshooting" section on page
13.
If the appliance requires repair, always contact Customer Expe-
rience - see enclosed guarantee. Always insist on original spare
parts. Repairs carried out by unauthorized personnel may be
dangerous and invalidate the guarantee.
DESCRIPTION
(page 3)
Appliance description (page 3 - A )
A1. Control panel
A2.Condensate collection tank
A3. Lifting handle
A4. Air intake grill
A5. Dust Air lter or silver-ion air lter (on certain
models only)
A6. Air outlet grill
A7. Condensate drain hose (approx. 1 m)
A8. Anti-allergen lter (on certain models only)
Control panel description (page 3 - B )
B1. ON/STAND-BY button
B2. MODE button
B3. Tank full/tank missing indicator light
B4. Dehumidication/frost protection function light.
B5. Set humidity level
INSTALLATION
Position the appliance in the room to be dehumidied. A free
space of at least 2 ft (61cm) must be left at the front of the dehu-
midier, so as not to block the air outlet. For ecient ventilation
a space of about 2-4 in (5-10 cm) should be left at the back of
the appliance.The condensate can be drained in one of the fol-
lowing ways:
a) Draining into the tank
The condensate can be drained directly into the tank. The tank
can be easily removed (Fig.1).
b) Continuous external draining
If the appliance is to be operated for long periods but you are
unable to empty the tank regularly, you are recommended to
use continuous draining.
1) Remove the continuous drain cap by turning it counter-
clockwise then remove the rubber stopper from the spout
2 (Fig. 2).
2) Apply the accessory tube to the spout as shown in Figure 3.
3) Make sure the end of the hose is no higher than the spout.
Otherwise the water will ow into the tank of the appli-
ance (Fig. 4).
Make sure there are no kinks in the hose.

6
use in cold environments, it is recommended to heat the room
at the same time, even slightly. This allows the dehumidier to
operate in conditions that ensure better performance and faster
dehumidication.
Please note!
• The appliance is equipped with a security device
(delay of 3 minutes) that protects the compressor
against too frequent starts and stops.
CLEANING AND MAINTENANCE
Always remove the plug from the power socket before perform-
ing any cleaning or maintenance operations. For safety reasons,
never wash the dehumidier using a water jet.
Cleaning the cabinet
• Clean the appliance using a damp cloth then dry with a dry
cloth.
• Never use petrol, alcohol or solvents to clean the appliance.
• Never spray the appliance with insecticides or similar. These
could cause the plastic parts to warp.
Cleaning the dust air lter or silver-ion air lter
(on certain models only)
If the lter is dirty, air circulation is compromised and the ef-
ciency of dehumidifying is decreased. It is therefore good
practice to clean the lter at regular intervals. The frequency
depends on the environment and the duration of operation.
If the unit is used constantly or systematically, you are recom-
mended to clean the lter once a week.
• To remove the air lter, remove the grill and extract the lter
by pulling it (see Fig. 5).
• Use a vacuum cleaner to remove dust accumulations from
the lter. If the lter is very dirty, rinse well with lukewarm
water.The temperature of the water should not exceed 40˚C.
After washing the lter, allow it to dry completely before re-
inserting it.
If present, the silver-ion air lter, besides retaining powder
particles, has also an ecient antibacterial action. In addi-
tion, it greatly reduces irritants such as pollen and spores.
The lter is treated with small particles of silver (on the scale
of millionths of a millimetre) which are able to block the
multiplication of and destroy any bacteria or spores coming
into contact with them.
Anti-allergen lter (on certain models only)
Some models are equipped with an anti-allergen lter that can
notably reduce the concentration of allergens transported by air
in a quick and ecient way.
HOW TO DEHUMIDIFY
• Connect the appliance into an outlet.
• Check that the "tank full/tank missing" indicator light
( ) is turned o, otherwise empty the tank or position
it correctly.
• To turn the appliance on, press the ON/STAND BY button
.
• Press the“MODE”(B2) button to select the desired humid-
ity ( ).
The appliance will adjust the humidity level according to
your choice:
Approx.
60%
environment humidity
Approx.
50%
environment humidity
Approx.
40%
environment humidity
Selecting , the “dry”function is activated, ideal to speed
up the drying of laundry.
Please note!
• If the humidity in the room is greater than the set
humidity, the appliance will start to dehumidify
and will stop functioning only when the desired
level of humidity is reached.
INDICATOR LIGHTS
Tank control light
(Tank control system)
This dehumidier is equipped with a device that monitors the
correct functioning of the appliance.
The corresponding indicator light, located on the control panel,
turns on to warn the user when:
1. the tank is full:
empty the tank
2. the tank is missing:
reposition the tank
3. the tank is positioned incorrectly:
position it properly
4. in continuous drain:
the hose is obstructed or the dierence in level is too great
(the water continues to be discharged into the tank)
remove the obstruction.
Once the cause has been eliminated, the light goes out and the
appliance resumes operation.
Low temperature operation indicator light
When the room temperature is too low, the electronic low tem-
perature operation device is activated. The device makes the ap-
pliance operate by alternating dehumidication cycles and fan
only cycles, thus avoiding the formation of frost. For frequent

7
To apply the lter, remove it from the packaging and insert it
into its place in the grill at the back of the appliance, as shown
in Figure 6.
It is recommended to replace the lter every 2 years.
If the appliance is not used for long periods
• After unplugging the appliance from the power socket,
empty the tank.
• Clean and reposition the lter.
• Cover the appliance with a plastic bag to protect it from dust.
TECHNICAL SPECIFICATIONS
Power supply voltage See rating plate
Absorbed power “
Frost protection device Yes
Fan speeds 1
Air lter Yes
Anti-allergen lter (only on certain models) Yes
Dimensions HxLxD 19.7 x13.15x8.66 in (502x334x220mm)
Tank capacity 2.1 litres
Operation limits:
temperature 35.6°F - 86°F (2°C-30°C)
relative humidity 30-90%

8
TROUBLESHOOTING
Check the following points before calling your local authorised Service Centre.
PROBLEMS CAUSE SOLUTION
The appliance is operating in dehu-
midifying mode, but the humidity
does not decrease
The lter is blocked
The temperature or humidity in the
room is too low
The room is too big for the dehumidi-
fying power of the appliance or there
are too many sources of humidity
(pots of boiling water, etc.)
The humidity set point is too high
Clean the lter
In certain conditions, it is normal for the ap-
pliance not to dehumidify .Verify the opera-
tion limits of the appliance in the "Technical
Specications" section. In certain cases, it is
recommended to heat the environment
Decrease the humidity set point
The appliance does not work for ap-
prox 3 minutes after start-up
The safety device has tripped Wait for 3 minutes to pass and restart
The appliance does not work
The appliance is not plugged in
There is no current
The appliance is set on
low humidity level
The tank is full of water
The tank is not positioned
correctly
Plug into the mains
Check the power supply
Set the appliance to a greater humidity level
Empty the tank
Gently place the tank
into the correct position
Other manuals for DEX Series
1
Table of contents
Other DèLonghi Dehumidifier manuals