Dacor EDWH24S User manual

INSTALLATION
INSTRUCTIONS
Epicure®and Millennia®Style
Handle Kits
DISHWASHER MODELS: EDWH24S, IDWH24, RDW24I and RDW24S
Part No. 106906 Rev. E
Parts Included
Epicure Style Handle Kits
ADWE24HCH (chrome):
ADWE24HB (black gloss):
Millennia Style Handle Kits
ADWM24H* (Polished nish):
ARDWM24H (Brushed nish):
Handle Part # 106909 Handle Part # 106908
* ADWM24H discontinued - subject to availability
Handle Part # 106909BG Handle Part # 105784
Tools and Materials Required
The following items are not provided with the
kit and are required for proper installation.
• 3/32” Allen wrench (not supplied)
Installation instructions on back
Introduction
The handle included with this kit is designed for installation on the dishwasher models listed
above:
• On models EDWH24S and RDW24S, the handle attaches directly to the front of
dishwasher using mounting hardware that is already attached to the front of the
dishwasher.
• On models IDWH24 and RDW24I, the included handle is designed to attach to glass
panel kits APIDWPBK or APIDWPMV that fit on the front of the dishwasher door. The
handle mounting hardware for this type of installation is included with the glass panel kit.
CAUTION: To avoid damage to the dishwasher or handle
components, do not use power tools. Use hand tools
only for assembly.

Dacor●600AntonBlvd.Suite1000CostaMesa,CA92626●Phone:(800)793-0093●Fax:(626)403-3130●www.dacor.com
Millennia Style Handle Installation
(ADWM24H/ ARDWM24H)
Epicure Style Handle Installation
(ADWE24HCH/ADWE24HB)
Handle mounting
studs
Handle mounting
studs
Set screw
holes
Set screw
holes
STEP 1 Place the handle on the front of the dishwasher. Slide
the holes on the back over the handle mounting studs.
Make sure the set screw holes on the handle are fac-
ing toward the bottom. You may need to loosen the set
screws using a 3/32” Allen wrench to allow the handle
to slide into place.
STEP 2 Carefullytightenthesetscrewsintoplaceusingthe
3/32”Allenwrench.Becarefulnottoscratchthenish.
STEP 3 Checktomakesurethehandleisrmlyattached.
STEP 4 Open the door to make sure it stays open at any angle.
If it tends to fall open or pull shut on its own, adjust the
springs according to the dishwasher installation instruc-
tions.
IMPORTANT:
For dishwasher models IDWH24 and RDW24I with glass panel kit: Install this
handle kit according to the instructions provided with the glass panel kit. For
dishwasher models EDWH24S and RDW24S, see the instructions below.
Instructions