Dacor EOR series Technical manual

All specications subject to change without notice. Phone: [phone]www.dacor.com
PLANNING
GUIDE
EOR, MOR
Document # PG01-003 Revised 12/06/11 Page 1/2
Classic 27”, 30”, 36” Wide
Single Wall Ovens
Model
Number
(A) Overall
Width
(B)* Chassis
Width
(C) Overall
Height
(D)**
Chassis
Height
(E) Control
Panel
Overlay
EORS127/
MORS127
26 7/8”
(68.3 cm)
25 3/8”
(64.5 cm) 28 7/16”
(72.4 cm)
27 1/2”
(69.9 cm)
15/16”
(23.8 cm)
EORS130/
MORS130
29 7/8”
(75.9 cm)
28 3/8”
(72.1 cm)
EORS136 35 7/8”
(91.1 cm)
34 3/8”
(87.3 cm)
28 1/8”
(71.4 cm)
27 1/4”
(69.2 cm)
7/8”
(2.2 cm)
* Width at light covers on sides
** To top of chassis notch behind control panel
(F) Utility
Cutout Width
(G) Utility
Cutout Height
(H) Utility
Cutout Depth
(J) Control
Panel Depth
(K) Notch
Depth
(L) Chassis
Depth
(M) Notch
Height
All models 5”
(12.7 cm)
5 ¼”
(13.3 cm)
6”
(15.2 cm)
1”
(2.54 cm)
1 1/8”
(2.9 cm)
24”
(61.0 cm)
1”
(2.5 cm)
21 1/8”
3 3/8”
(8.6 cm)
1”
(2.5 cm)
1”
(2.5 cm)
Epicure Millennia -
(Handle is integral)
HANDLE
DIMENSIONS
Model
Number
Dedicated Circuit
Requirements
Total Connected
Load
EORS127
240 Vac 60 Hz.,
4-wire***, 30 Amp.
5.0 kW (20.8 Amp.)
MORS127
EORS130
MORS130
EORS136 5.3 kW (22 Amp.)
*** Two 120 Vac hot (L1 and L2), one neutral, one ground
The above specifications are for reference only. See the appliance
data plate for exact specifications.
C
J
B*
H
G
F
A
Chassis Notch
Side View
Control panel
front Top of
chassis
Top of
chassis
Utility
cutout
Light
cover
Conduit:
60” (152 cm)
Long
K
L
M
E
D
All tolerances: ±1/16” (±1.6 mm) unless otherwise stated
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.

All specications subject to change without notice. Phone: [phone]www.dacor.com
PLANNING
GUIDE
EOR, MOR
Document # PG01-003 Revised 12/06/11 Page 2/2
Classic 27”, 30”, 36” Wide
Single Wall Ovens
1 1/2”
(3.8 cm)
typical counter
1“ (2.5 cm) Min.
to combustible floor
3/4” (1.9 cm)
support platform
1“ (25 mm) Min. to combustibles
Recommended
electrical
location
4” typical toe kick
36”
(91.4 cm) P
R
SINGLE WALL OVEN - INSTALLED UNDER COUNTER
Recommended
electrical
location
Alternate
electrical
location
4” typical toe kick
N
P
R
3/4” (1.9 cm)
support platform
31 1/4” (79.4 cm)
recommended
1” (2.5 cm) Min.
to bottom of
cabinet door
1” (2.5 cm) Min.
to top of
cabinet door
SINGLE WALL OVEN - CUT OUT DIMENSIONS
Model Number (N) Minimum
Cabinet Width
(P) Minimum
Cut Out Width
(R) Minimum
Cut out Height
EORS127/
MORS127
27”
(68.6 cm)
25 ½”
(64.8 cm) 27 5/8”
(70.2 cm)
EORS130/
MORS130
30”
(76.2 cm)
28 ½”
(72.4 cm)
EORS136 36”
(91.4 cm)
34 ½”
(87.6 cm)
27 ½”
(69.9 cm)
Minimum Interior Cabinet Depth: 24” (61.0 cm)
All tolerances: +1/16” (+1.6 mm) -0, unless otherwise stated